Can you say why you were applying heat when you were hammering with your orange hammer? I understand putting one in the freezer and heating up the bearing but did not understand why during hammering. Thanks.
@@TakesTalent same what he is using on the video. Check TQ specs to make sure they are correct for m5! He is not correct on all the TQ numbers. I think I’ll go to a shop to have this done, no time honestly to do it myself.
Fairy liquid on the shaft works wonders.
Done this job on my Granada Mk2
that was a good video and very detailed. good use of your knowledge of science and materials behavior by heating and cooling the opposite pieces.
Great video! Btw, rear bearings are 2x ball bearings, not tapered rollers.
The four wheel bearing bolts are 30NM + 90 degrees.
Did you also feelt slight vibration at highway speeds ? Thanks keep them e39 vidz coming !
No vibration.
Can you say why you were applying heat when you were hammering with your orange hammer? I understand putting one in the freezer and heating up the bearing but did not understand why during hammering. Thanks.
Heating up the old bearing/hub assembly makes it a bit easier to remove from the axel.
Is it same procedure for ‘03 e39 m5
im about to do it on my e39 M5
@@gfcphotography3101 what tools do you need
@@TakesTalent same what he is using on the video. Check TQ specs to make sure they are correct for m5! He is not correct on all the TQ numbers. I think I’ll go to a shop to have this done, no time honestly to do it myself.
ЗАПРЕЩЕНО !!!!!смазывать направляющие тормозов.
Они открытого типа на смазку на липнет грязь. Смотреть TIS.