I have constantly had problems with these knobs binding up on me. Not only the multi-panel as shown here but I was also having problems with the engine switch binding on the Saitek switch panel. This fix worked perfectly for both of these. I can't believe how simple it was. Thanks Mark
This is the correct method . My control switch sized up till I could not turn it. a half second spray of WD40 and it is back to normal. all this can be done without removing the panel from the cockpit.
I have constantly had problems with these knobs binding up on me. Not only the multi-panel as shown here but I was also having problems with the engine switch binding on the Saitek switch panel. This fix worked perfectly for both of these. I can't believe how simple it was.
Thanks
Mark
Thank you sir! You should post this on the forums. I have seen a lot of people asking for solutions, and your video would calm a lot of nerves.
This is the correct method . My control switch sized up till I could not turn it. a half second spray of WD40 and it is back to normal. all this can be done without removing the panel from the cockpit.
Super, is a very big help and worked perfectly! Great thanks
Brilliant - still works like a charm in less than a minute - thank you very much.
It worked! And I was just about to try opening the entire panel...
That's it. I've been looking for that. Thank you.
Thank you sir!
Thanks....That worked Great..... :)
brilliant..worked a treat!..thank you
Silver knobs can get off too¿
Thanks man.
My switch panel once connected to power landing gear lights blinks once
then off i.e does not get connected to power. Any advice please?
thank Bro it fix my
Will this work with wd40?
great I did it with olive oil :) thanks
Olive oil will become sticky
My switch panel once connected to power landing gear lights blinks once
then off i.e does not get connected to power. Any advice please?
My switch panel once connected to power landing gear lights blinks once
then off i.e does not get connected to power. Any advice please?
My switch panel once connected to power landing gear lights blinks once
then off i.e does not get connected to power. Any advice please?