HOW TO PREPARE AND DO MAINS GRID SYNCHRONIZING

In this video I explain the preparation and the module type, how it will work in the actual condition, and also I explain the breaker which is the mains breaker, bus breaker, generator breaker who's is controlling with this and what are the configuration needed for this grid sync

[@mrvmax7078]

TAMSAK Done New friend here kaibigan

[@benzblogsVlogs]

Hi

[@jubsofficialvlog1473]

Lods gandang gabi.ayis lods

[@benzblogsVlogs]

Yes lods

[@RomeoAgor-k8c]

ano ba ang brand ng oil pressure sensor at paano e configure

[@benzblogsVlogs]

Marami Ang brand n pweding magamit sir Kong ma config naman dapat nakaw base ka sa manual Ng sensor na gamit mo Kong 5 or 10 bar ba dependi Yan sa klasi

[@njperez1310]

Sir may inquery po ako. Dpo sya related sa grid synchronizing. Im having trouble synchronizing 2 perkins 4008 series engine. It has a woodward proact model I digital speed control which i connect to dse 8610MKII. from dse wiring topology, i installed 2 interposing for speed raise and lower. It is connected to dse digital output (speed raise/lower relay) on governor side it is connected to terminal 18 and 19. When i tested the unit, i noticed that there is a contact delay on the interposing relay. Do have any suggestion on how to resolve the issue. Can i make use of aux voltage input of governor (terminal 12 &13) and connect to dse internal analogue (terminal 35 & 36). Or do i have to change the governor to model II, so that it can communicate directly to dse.

[@benzblogsVlogs]

Much good use the analog from dse control going to your engine my i ask this engine using ecu or heinzmann governor?

[@njperez1310]

It is using woodward proact model I digital speed control

[@njperez1310]

It is a conventional diesel engine 4008. Based in dse topology, internal relay should be choose. Install two 24Vdc interposing relay to control the speed raise and low

[@RomeoAgor-k8c]

for deep sea controller

[@benzblogsVlogs]

Just use vdo 10 bar