Stihl 021 Connecting Rod Crankshaft Uncaged Needle Bearings Install
HTML-код
- Опубликовано: 26 авг 2024
- Placing uncaged connecting rod crankshaft needle bearings back in a Stihl 021 and also a Stihl 025. Sometimes we tear down a engine and forget that some bearings are uncaged and they go everywhere. A high tach oil would probably work better than grease but you take what you got and work with it.
Starting a small engine shop from the ground up takes alot of work and determination. If anyone would like to donate or invest in this small business I would be very thankful.
PayPal andymanthony@aol.com
God Bless!!
Put a magnet on crankshaft makes it easier
Glad I found this video was about to throw out my 015l got a parts saw with a good cylinder so I ported and polished it went to put it on my mint 015l all the bearings fell out but she is back together now and runs alot stronger now it was my first port and polish job I was some upset until I found this video thanks alot you have a new sub now lol
Just experienced that adventure!!
I have a 1977 skilsaw1610 and all of them fell out this will help allot
Nice tutorial by the way
Thank you
Is it correct that I count 14 pins?
That's seems hard I'm gonna tear one apart tomorrow
Stick one end of the crank shaft in a vice with hard wood spacers, then you'll find it HEAPS easier!
Mike MacDonald thanks for the information I will use that on the next build
Wonder what would happen if ya magnetized the needles first?
That was an early 1. Those used the same construction the 009, 010, 011 & 012 used. Use grease & make damn sure you don't lose 1. Stihl makes a tool for that.
I would probably use very heavy solid grease to let needles stick in place and after installation of shaft flush grease with diesel or petrol .
I use vaseline, because it's petroleum jelly.
That just happend on my 010 Darn anoyying .
Never will attempt this again 3 times after installing back in case fell out through in trash ✌️
could you please respond, did you measured the pins? i would like to improvise something but i need some specs, thank you have a nice day
ps on internet i didn-t find specs of the pins
hi, i have the same problem and lost the pins, do you have some specs for the pins? diameter/lenght? thank you
Length 7.00mm diameter 3.52mm