Very informative brotha. Can you do 6 networks with 3 routers next pls? It goes like this: 6PCs 6switches 3Routers For ex: pc 0 and 1 w/ Lan 1 and 2 connected to HQ, like that
You used a default gateway of 192.168.11.10 for network B at the beginning but you later used 192.168.11.0 while doing routing, is that meant to be a mistake?
THANK YOU. I CAN FINALLY FINISH MY HOMEWORK IT WORKED
You're welcome!
Thank you so much for the informative video. You're the best 🙏
Thankyou so much for ur hardwork, its very helpful to us
All the best
Lot of knowledge about networking
Informative video..Rise n Shine dude Thank you
Excellent and knowledgeable 👍
Thank you
Way of explanation is very good, make more video constantly.
Very helpful thankyou
Thank you sir
Nice video knowledgeable
Keep it up; nice explanation
thank you very much! it really helps with my study tasks!
You're very welcome!
Good 👍👍
Thank you sir
Thank your very much for good job.
Thank you too!
Thanks a lot for teaching!!
From PH
Welcome
You're very welcome!
Keep it bro..good explanation
Thanks bro
Wow very good teacher
Thank you! 😃
Good
❤❤❤
Very informative brotha. Can you do 6 networks with 3 routers next pls?
It goes like this:
6PCs
6switches
3Routers
For ex: pc 0 and 1 w/ Lan 1 and 2 connected to HQ, like that
Ok
Thankyou so much sir
Most welcome
👍
Glad you like it
you should set the next hop as the ip address that is associated with the routers interface, but not the network address
There are multiple ways to assign ip addresses for hop.
You used a default gateway of 192.168.11.10 for network B at the beginning but you later used 192.168.11.0 while doing routing, is that meant to be a mistake?
No it's a way of routing configuration
can you do site to site vpn with Cisco ASA? thanks for the video.
Yes I can
How To configure two VLANs (one for wired LAN and one for WiFi) in Cisco Packet Tracer,??
kindly share any video based on this question..
Ok
thanks for your reply. i am waiting for your video. which is mentioned above.@@Cisco_Networking_Academy
Is this a mesh topology
No, watch how to make mesh topology in cpt.
tracert command doesn't work fine :(
can you please do to add only one dns server
Ok
@@Cisco_Networking_Academy thank you and i appreciate your work ........
Too goo😢
Why my router overlaps
Recheck the addresses of the routers
@@Cisco_Networking_Academy thankz
I think it's not 3 network because they have the same subnet mask
Do subnetting bro
t.me/Cisco_Packet_Tracer_Networking
For any Queries
Join this
Thanks for the feedback
Waste of time doesnt work
Itna acha to padhaya hai bhai
❤❤❤