How to make a Separable Hydraulic Wire Crimping Tool

Hello my dear friends, in this video I'm going to show you.How to make a Separable Hydraulic Wire Crimping Tool. Thank you for watching!! Please subscribe to my channel.!
Thank you for watching your video. Please share your video to support me!
Love all of you :)
----------------------------------------------------------------------------
© Copyright by KST HACKS ☞ Do not Reup
----------------------------------------------------------------------------
#KSTHACKS #SeparableHydraulic #WireCrimpingtool

[@shanhannum9999]

Nothing better than being able to make your own tools, yes he could have bought one. But being able to make your own tools takes patience and knowledge. I always took pride in making my own

[@Dutcharmytent]

Quick tip. Drill a 1/8” pilot hole in the steel plate then a 1/2” hole. The 1/2 drill bit has an area on the very tip that does not cut. The land slows the drill down.

[@Rcovichpp]

Gracias por compartir para muchas personas como yo es muy importante ese tipo de herramientas que se puede hacer en el taller que es muy útil

[@lusa3002]

Un martillo y un tornillo de 3/8 y listo.

[@henryscorpio2256]

Keren bang 👍👍

[@bizzaro4999]

Guud aidie...👍👍

[@rafaelgonzalez4935]

Buen trabajo y buena heramienta la que fabricante yo ten go que conpral una heramienta de crinping para un trabajo

[@wanofficial7187]

Semangat bang💪 mamfir bisalah

[@lazarusramaube8291]

This video could have been done in 3 minutes,in addition, it would be cheaper to just buy the tool or use a hammer

[@CISTAF]

Good👍👍👍

[@ksthacks]

Thanks for the visit

[@electrolatif]

I have the same idea.hhhj but i dont know where to start😂😂😂😂

[@cdgoswami2947]

Required

[@iantherealg]

Sharpen that drill bit homeboy

[@keeganharmon8595]

and use tapping fluid or some kind of oil when drilling steel like that for Christs sake. no wonder that poor drill was struggling to perform as it should!

[@addy4590]

ρяσмσѕм