Brake Bleeding - Gravity method

Поделиться
HTML-код
  • Опубликовано: 2 окт 2024
  • In our last video we talked about different types of brake fluids and their characteristics. In this video we show you a time honored and tested, albeit slow, way of bleeding your brakes. No special tools are necessary, just patience.

Комментарии • 40

  • @noey5766
    @noey5766 2 года назад +2

    Wow! Never thought I would enjoy a video where the demonstrations were not done on a real car. This was perfect. Thank you sir!!

  • @klwthe3rd
    @klwthe3rd 5 лет назад +28

    This video is probably the single best video on the real explanations and benefits of gravity bleeding. The only thing I would note is sometimes when you crack the bleeders, fluid does not want to flow straight away. In some cases, it's good to pump the brakes BEFORE you open the master cylinder cap and crack the bleeders. It creates the needed pressure so when you crack the bleeder, the flow of old fluid will start to flow. I have seen many people crack their bleeders, wait 40 minutes to an hour and no fluid was being gravity feed out of the line. I told them to close/tighten all the bleeders and tighten the master cylinder reservoir cap. Pump the brakes several times over and over. Then follow the process outlined in this video. Hope it helps.

  • @topenddean
    @topenddean 4 года назад +1

    Best video yet for explaining gravity bleeding.

  • @DavidS11
    @DavidS11 6 лет назад +23

    The Bob Ross of Automotive repairs

  • @hughcarroll649
    @hughcarroll649 7 лет назад +1

    Great video as I just reinstalled my master cylinder yesterday.

  • @michaelreece458
    @michaelreece458 6 лет назад +6

    Brilliant method of bleeding brakes. Pull up a chair, light up a big cuban Cohiba, a shot of Chivas, keep the reservoir topped up and presto!...fresh brake feel!

  • @johnhotrod3231
    @johnhotrod3231 2 года назад +1

    Thank you. One question, if air is in the master cylinder, will this process evacuate that air, or will the fluid entering the master cylinder from the reservoir just bypass the air and continue down through the brake line at the same rate it enters the master cylinder from the reservoir effectively leaving the air in there?

  • @dgriffin6074
    @dgriffin6074 4 года назад +2

    As always from Moss Motors, well done. It is a good idea to purchase a brake fluid tester to check water content. They are inexpensive.

  • @F1BOY2007
    @F1BOY2007 6 лет назад +8

    i can listen to his voice all day long.. makes me want to do it .:-)

  • @rayjvify
    @rayjvify 4 года назад +1

    I don’t even own a car but this guy sounds so convincing I bleed my neighbors car . This system works ok on vehicles , but not so much on motorcycles ......... beware . Personally , nothing bleeds like a pressure bleeder .

  • @EppingForest304
    @EppingForest304 7 лет назад

    Very well explained!

  • @ppeterson9359
    @ppeterson9359 5 лет назад +2

    On an MGB, the bleeders of the rear cylinders are on the bottom rather than on the top. Will gravity bleeding still work? Seems like an air bubble will forever be trapped.

    • @jonniejam-shovel6405
      @jonniejam-shovel6405 4 года назад

      P Peterson. Good point. Can I ask you, is your MG fitted with a servo? I was taught that vehicles fitted with this component needed the engine running to bleed the brakes. Any thoughts? Cheers.👍

  • @ukexbreakdownman
    @ukexbreakdownman Год назад

    well explained smart man i think weve all been there at some poin twhy buy expensive pressure bleeders simple works best

  • @canadianmarauder1923
    @canadianmarauder1923 4 года назад +1

    This is exactly what I gotta do on my 03 marauder. I never knew the old pumping up the brakes method could actually damage the seal on master cylinder piston or spool thingy. Very good information

  • @kalani1987
    @kalani1987 Год назад +1

    I've heard that instead of starting on the wheel furthest from the master cylinder, start furthest from the ABS module, if equipped. Thoughts?

    • @AUDIO2AUTO
      @AUDIO2AUTO Год назад

      The abs module is usually under the master cylinder.

    • @kalani1987
      @kalani1987 Год назад +1

      @@AUDIO2AUTO on my car the abs is located toward the front right of the engine bay and master cylinder in the rear near firewall

    • @AUDIO2AUTO
      @AUDIO2AUTO Год назад +1

      @@kalani1987 oh ok, but it really doesnt matter where you start long as all the air is out. The front and back are on separate lines anyway and are not connected as a fail safe other than when the master cylinder is out of fluid.

  • @scottwest1813
    @scottwest1813 5 лет назад

    Great video.

  • @anthonyhfe6450
    @anthonyhfe6450 2 года назад

    Can this method be used with a new master cylinder on a '72 MGB? Is the procedure the same?

  • @2002Term
    @2002Term 3 года назад

    Will this process work with abs equipped vehicles?

  • @werdCanada
    @werdCanada 2 года назад

    the bob ross of bleeding brakes

  • @lancercool1992
    @lancercool1992 4 года назад +1

    You have very easily earned a subscriber

  • @MrWilliam.Stewart
    @MrWilliam.Stewart Год назад

    Vacuum bleeding is common. But as my science and electronic teacher liked to say "gravity sucks"
    Liked you video, 👍

  • @williamshelton9688
    @williamshelton9688 Год назад

    What’s with the hands ?

  • @adamledger1646
    @adamledger1646 7 лет назад +2

    I love these videos, please keep doing them

  • @rc121crx
    @rc121crx 5 лет назад +1

    Mr. Mackey mmkay

  • @davidbi35
    @davidbi35 4 года назад

    Gravity way is the easiest and safest. Good video job.

  • @richardclark716
    @richardclark716 5 лет назад

    Will this method change the fluid on the low pressure side of the piston below the replenishment port ?

  • @susandavies8456
    @susandavies8456 3 года назад

    MGB gt for sale

  • @sntruck
    @sntruck 6 лет назад

    Nice N Easy, Steady As She Goes

  • @ericabercrombie6780
    @ericabercrombie6780 5 лет назад

    Narrator sounds like a cross between Casey Kasem and Alec Baldwin

  • @Ashroyer86
    @Ashroyer86 5 лет назад

    This guy sounds like a dentist or something.

  • @GODxDAMxLITRExOxCOLA
    @GODxDAMxLITRExOxCOLA 7 лет назад +2

    Is it possible to change the mic set up. I find it hard to focus with the constant lip smacking.

    • @rickyhill2047
      @rickyhill2047 7 лет назад +1

      STOP CRYING ABOUT SOMETHING SMALL.

  • @eksine
    @eksine 7 лет назад +3

    I'm not deaf why the hand gestures? fake sign language?