could you explain a little bit how the loop; orientation is? from what i can see you have both tubs from each component going to the back and just one tube returning to the reservoir. where is it leaving the reservoir to go into the components? unless im just blind and over thinking it lol
@NickNubbz Sure! The output of the pump (going to the components) is actually in the front going through the base plate by the resivour. I used a pass through connector with a barb fitting to allow the use of flexible hose. The idea is that these hoses are not seen and allows for easier connection. So no need to make these pretty. I did a crossing pattern, so the cpu rad is on the right, and the gpu rad is on the left. The outlet of the pump goes to the designated rad and then goes to the component for cooling through the pass through connectors on the plexiglass (the four passthough connectors in a row). Two are inlets to the components, and two are outlets. The outlet of the components goes to the top of the designated resivour and the connection is made in the back of the pc with flexible hose. Hopefully this helps!
Looks so cool!! Your excitement at the end was fantastic lol
i did some case mods to mine but idk why i didnt think of the flat surface. it looks great!
could you explain a little bit how the loop; orientation is? from what i can see you have both tubs from each component going to the back and just one tube returning to the reservoir. where is it leaving the reservoir to go into the components? unless im just blind and over thinking it lol
@NickNubbz Sure! The output of the pump (going to the components) is actually in the front going through the base plate by the resivour. I used a pass through connector with a barb fitting to allow the use of flexible hose. The idea is that these hoses are not seen and allows for easier connection. So no need to make these pretty. I did a crossing pattern, so the cpu rad is on the right, and the gpu rad is on the left. The outlet of the pump goes to the designated rad and then goes to the component for cooling through the pass through connectors on the plexiglass (the four passthough connectors in a row). Two are inlets to the components, and two are outlets. The outlet of the components goes to the top of the designated resivour and the connection is made in the back of the pc with flexible hose. Hopefully this helps!
@ that’s honestly genius! I wish I would have thought to use flexible tubing for the back because using hard tubing for the whole thing was a pain!
Do you have the blueprint for those cut out bottom and back ? Would be great man.
I unfortunately do not. I did not really think about transferring the templates to solidworks before I fully assembled the computer.
@@Ne-jc2vl thanks for reply. I’m trying to make that bottom and back plate same way. Just wondering about the size.