How to Replace Spark Plug 2001-2007 Volvo V70
HTML-код
- Опубликовано: 10 сен 2024
- Buy Now!
New Spark Plug Set from 1AAuto.com 1aau.to/ia/1AET...
This video shows you how to install new spark plugs on your 2001-2007 Volvo V70. Spark is one of the four required components for an internal combustion engine to run. If your spark plugs are failing, worn, or dirty, you may experience rough starts, rough idle, poor performance, or poor mileage.
This process should be similar on the following vehicles:
2001 Volvo V70
2002 Volvo V70
2003 Volvo V70
2004 Volvo V70
2005 Volvo V70
2006 Volvo V70
2007 Volvo V70
Tools you will need:
• Pocket Screwdriver
• 10mm Socket 1aau.to/ofX/1AX...
• 14mm Socket 1aau.to/ogW/1AX...
• 15mm Socket 1aau.to/ogW/1AX...
• 18mm Socket 1aau.to/oc3/1AX...
• 7mm Socket 1aau.to/ofX/1AX...
• 5/8 Inch Spark Plug Socket
• T25 Socket 1aau.to/oa2/1AX...
• T30 Socket
• Ratchet 1aau.to/ohH/1AX...
• Torque Wrench 1aau.to/oet/1AX...
• Drill
• Dielectric Grease
Subscribe: / @trq
Check out our playlist:
Volvo V70 2001-2007 2nd Generation: • Volvo V70 2001-2007 2n...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
Just did the plugs on my 2007 s60 2.5t AWD. All the bolt sizes matched perfectly. This video made it easy. Spec on the plugs was 21 ft lbs for me. Used a compressor to blow out some minor debris before pulling the plugs. You can just detach the front half of the charge pipe and it gives you plenty of room to move it outta the way to access every bolt/plug.
Thanks for the torques. That helped me.
Is this the same
Procedure
For the 2.5 T
That is the 2.5T
Btw anyone doing this for the p2 version the coil plug clip might look a little different but it is that same process.