Vans RV-8 Right Fuel Tank Interior rib sealing Ep 50
HTML-код
- Опубликовано: 2 окт 2024
- Sealed the remaining interior ribs on the right fuel tank. Feels good getting the tank to this point just demoralizing knowing I have to do it all over again on the left tank. Hope you enjoy.
Here is a link to the tinkercad file I created the cap seal tool from. Hope this helps. www.tinkercad....
Listed below are my affiliate links to some of the tools you have seen me use on this channel so far. If you are going to buy them anyways then I appreciate the support. Hope you enjoy and leave your questions or comments below.
Silicone Sealant spatulas amzn.to/3RHBk02
C Frame and squeezer yokes clemsonaeronau...
Endoscope amzn.to/4afKjvD
Label printer amzn.to/49lFlx6
Welder amzn.to/3uLht81
Measuring etc:
Machinist Square amzn.to/3T1F4t9
Combination Square amzn.to/49X6ffy
Straight Edge amzn.to/3V3xVv0
Angle Finder amzn.to/3T43dze
Epoxy Resin work:
3M respirator mask amzn.to/3uJDT9G
Rubber Gloves amzn.to/3Tk9XKz
Digital Scale amzn.to/49Zuyth
Mixing cups set amzn.to/4bT0UYp
Self Etching Primer amzn.to/48FBrPp
Sanding Block amzn.to/4bYH51E
Rasp amzn.to/4bYRYk8
File Set amzn.to/49y10mw
Sanding Sponges amzn.to/4c1kXng
West Systems Resin kit amzn.to/43hVYbL
Electrical:
Magnifying Lamp amzn.to/48Bcqoh
Molex Micro-fit connectors amzn.to/3uRKO0t
Cable Snap Bushings amzn.to/48U3ACt
Dupont crimp tool amzn.to/49BmdMw
Helping Hands amzn.to/432ScTl
Where did you buy the sealed nut plates from? And do you have a part number for the ones you used?
B&B aircraft supply NAS1473-A08.
Would you be willing to share your stl for the capping tool?
As for the filling of water, I just read a thread on vansairforce and it was brought up that the surface tension of water is greater than avgas. So it may still leak fuel but not water.
As soon as I get in later I will try to post the link to the STL file for anyone interested. I ended up reading the same on Van Airforce after I posted the video. I’ll just continue to trust the process.
Here is a link to the tinkercad file I created the cap seal tool from. Hope this helps. www.tinkercad.com/things/6aDyxIV5JA4-cap-seal
@@TFlight77 Finally got around to following the link and it says it's dead... could you re-upload it for a bit? hoping to start sealing my tanks in the next week or so. I'm working on a 7. Thanks!
@@norwichcadet www.tinkercad.com/things/6aDyxIV5JA4-cap-seal?sharecode=IgXPw6e8Gh6AwFLulW39EhLAReSoK-9YXHPmNgqyTXM