You might want to clarify that not only does the crank need to be at TDC, but also on the compression stroke. Otherwise one of the valves is going to be partially open and you’ll get incorrect clearances with your feeler gauges
only need to be at tdc which stroke it is doesn't matter. If the piston is at TDC the valves will always be closed. Single cylinders don't have to worry about any of that other stuff
Screw type adjusters are an "easy" job, but buy the Motion Pro Tappet Adjustment Wrench Set, makes the job SO much easier, especially in places with minimal clearance like doing the intake valve.
What are the specs for the intake?
My Monkey doesnt have a T mark, it has "I" line, than another "I" line and than "III" lines. Which one is TDC? It´s a 2023 Moneky
You might want to clarify that not only does the crank need to be at TDC, but also on the compression stroke.
Otherwise one of the valves is going to be partially open and you’ll get incorrect clearances with your feeler gauges
only need to be at tdc which stroke it is doesn't matter. If the piston is at TDC the valves will always be closed. Single cylinders don't have to worry about any of that other stuff
@Phil M you can feel it
@Phil M Valve tappets feel loose and not firm.
Need to do this on the compression steoke.
Very helpful. Thank you
Screw type adjusters are an "easy" job, but buy the Motion Pro Tappet Adjustment Wrench Set, makes the job SO much easier, especially in places with minimal clearance like doing the intake valve.
Will the motion pro 9mm tool fit up on the intake side with just removing the front airbox element cover? I'm pondering buying one. Tnx for any info.
@@findingneutral Don't know, I took my airbox off and would recommend the same, easy enough and you won't have access issues.
NEVER do valve adjustment on a warm engine let alone hot engine! ⚠️
Hey, what size tool do I need for the small engine plug? I heard you say the large was 14mm. Also they are hex keys right?
spark plug is 16mm
DaBinChe no, the plug at .47 what size tool do I need to remove that small plug?
@@baldilocks1914 a coin or large flat head screw
6mm hex head for the timing mark plug; 10mm hex head for the crank cover.
Is it a super cub 50? What is the clearance at the intake valve?
SuperCub125, don't recall what the clearance was, should be in the video
Any ENGLISH Speaking ????????????????????