Designer Toy Process Tutorial: Sushi using M5s Pro

[@propsandpop]

Good job man, very cute!

[@sleepingslightly]

"GATEKEEPING NOTHING!" Beautiful lil nigiri, bud🤙🏾

[@abovewongart]

Tysm 😊

[@mrbear8771]

Great work Man 👍 didn’t realize how much work goes into preparing it before you paint it. I feel like a bit of a douche just throwing out suggestions when I see how much work you put into it. Again great work 👍

[@zanburning1268]

awsome work

[@iChromie]

Bro your vida are always well edited and your voiceovers are great. Keep making bro 💯

[@iChromie]

2:23 "people ask me if I work om any tolerances... I don't know what that is!" - this made me cackle for longer than I'd like to admit

[@jershin_around63]

Cool toy! After your liquid wasted bucket fills, where do you get rid of it?

[@DanaTYang]

oh thats why you used the UV flash light. was wondering what that was in the IG short.

[@DanaTYang]

haha "push hard through the sucking stage", that's where i feel I'm at right now!

[@shadowblack1987]

Don't sand until it been washed and final cure done.

[@abovewongart]

It doesn't matter really. It's up to you. Both work fine

[@HO-cj3ut]

Anycubic resin, what are your user opinions about the resin used?

[@abovewongart]

its amazing but catered for protypes and fast rough drafts because its max potential is achieved with .1mm layer height

[@amirs3600]

slt?