⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: ruclips.net/user/AutoRepairGuys ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
I have a leak dripping from under my glove compartment in an E90 328i 2008. Is it possible to have a leak from under the upper windshield cowl? Is there supposed to be adhesive holding that portion on that avoids water build up under the cowl?
@@itsfinn9644 I fixed by applying black 5200 silicone around the base and sides of the windshield. There seems to have been some gaps in the windshield sealant.
thanks for this video. will come in very useful, I have noticed a wet floor drivers side and need to investigate. the windshield trim on my 1 series overlaps on the drivers side allowing it to lift and dirt getting in creating a gap. I am Hoping a good clean once all taken off should fix the problem. anyone any other ideas why I would have a wet floor, much appreciated.
Hey just a quick question. So i just installed a new headlight on my fiesta st and after installing it, i started the engine and then turned the headlight switch to on, then everything shut off. Now i have no power going to anything in the car, any ideas on what relay or if there is anything i should check?
⛐ Check out our Garage to see what tools we use and recommend:
www.amazon.com/shop/worldmechanics
⛐ Subscribe and hit the notification bell by the subscribe button for new videos: ruclips.net/user/AutoRepairGuys
⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
When you disconnect the hose bracket from the lower cowl is it simply pulling it forward? Are there no clips holding this piece in place to the cowl?
You will pull forward on the lower tab
Is there a trick to re-install 328xi wiper cawl trim. It is not shoeing in to the base edge of the windshield?
I have a leak dripping from under my glove compartment in an E90 328i 2008. Is it possible to have a leak from under the upper windshield cowl? Is there supposed to be adhesive holding that portion on that avoids water build up under the cowl?
Following cuz I have the same problem on my 2011
@@itsfinn9644 I fixed by applying black 5200 silicone around the base and sides of the windshield. There seems to have been some gaps in the windshield sealant.
@@johnbowman4424 was that aquamarine silicone?
@@runokohamilton3537 yes sir
@@johnbowman4424 do you mind explaining to me how you did it?
Hi guys. Thank you guys for this video guys. It really guys helped guys me guys. Guys guys guys guys guys.
thanks for this video. will come in very useful, I have noticed a wet floor drivers side and need to investigate. the windshield trim on my 1 series overlaps on the drivers side allowing it to lift and dirt getting in creating a gap. I am Hoping a good clean once all taken off should fix the problem. anyone any other ideas why I would have a wet floor, much appreciated.
This channel Great!!
Thank You!
At 6:25 what seal is that or part number?
Hey just a quick question. So i just installed a new headlight on my fiesta st and after installing it, i started the engine and then turned the headlight switch to on, then everything shut off. Now i have no power going to anything in the car, any ideas on what relay or if there is anything i should check?
Maybe you should disconnect the battery before doing the lights🤔
Thanks for the excellent video gentlemen
Can you remove and replace the upper windshield cowl without actually removing the bottom one?
Not very easily. The top one has an edge the fits into the bottom one.
Good video !
Merci 👍
My cabin filter houseing won't go back in place
Have to make sure that you keep the back side pressed down as you slide it back in.
Much better
Can you make a short video on replacing the upper windshield cowl? Mine is broken.