Toyota Corolla Wheel stud replacement
HTML-код
- Опубликовано: 6 мар 2021
- How to replace the wheel studs on 2016 Toyota Corolla.
Easy step by step guide on removal and installation of rear brake drum wheel hub studs.
To drive in the studs you'll need an open ended nut and a washer.
wheel studs part # 610-266-1 amzn.to/3adv8aH
wheel nuts open ended # 611-133-1 amzn.to/3jM9ZHz you can also buy the close ended nut if you want, since the original nuts are. amzn.to/3advMVF - Авто/Мото
Fantastic demonstration
Thanks
Thank you for this.
Np
good job budy thanks
Thanks you too
How do you put the vehicle in neutral without touching the brake?
Hello
You can try by removing the brake switch from its base then shift it to neutral.
Any other ways of getting the plate covering the studs off?
Yeah there is, you'll have to remove the wheel hub bearing assembly.
There's two holes that hold the rotor down, remove those and find two similar but longer ones. Tighten both back and forth until it wedges the rotor off the brake assembly.
will electric mastercraft be strong engough to pull that stud through?
Why else did you change to Air gun Let me know..
Yes, electric mastercraft gun should be good enough as long as its rated more than 450ftlbs of torque.
I used air gun because its the fastest, efficient and its the only tool that i have.
GL
@@Cargoragehas to be more than ? Or at least 450?
@@Malacheeee at least. The more power, the faster the job.