Is it normal for the sway bar end to spring upwards once stability link arms are removed and then have to lever the sway bar downwards in order to attach stabiliser link rods when refitting??
@@skytech_00 You basically final torque the bolts when the control arm is in position when standing on the ground. But don't stress about this too much, if you did not load the control arm it will be fine.
Is it normal for the sway bar end to spring upwards once stability link arms are removed and then have to lever the sway bar downwards in order to attach stabiliser link rods when refitting??
Yes that's pretty much normal
What are the common causes for engine check light in Mazda 6, planning to get one 2014 Mazda 6. Pls advice
You will need to scan for codes. The most common on Mazda's is rust underneath.
I just replaced these items....lots of squeaking......will this go away after a wheel alignment?
We did not lubricate any parts
Hello, You should not have any squeaking noise after this job. Please double check everything. Was it squeaking prior the job?
did you load the suspension before tightening the control arm bolt? if not it will be clunking in no time
Yes sir always. I should have explained that on the video also.
What do you mean by load the suspension?
@@skytech_00 You basically final torque the bolts when the control arm is in position when standing on the ground. But don't stress about this too much, if you did not load the control arm it will be fine.