After reading haynes manual instructions and watching other videos I was not looking forward to doing this job but after watching this video I couldn't wait to get started. Jobs a goodin all sorted now 👍 Thank you 🤝
Dude this video is excellent… no talking, no tool lists, everything is sped up and it just shows you what to do… the chipmunk’d voice bites are an Easter egg
I agree, the usual 20 minute intro of why they haven’t uploaded lately, and why the camera angle isn’t good ect ect ect gets really old when you just need to see 30 seconds of how something comes off…
At low speed, my steering wheel shakes and pulls a little to the left, the wheels are balanced and the running angle is done, it may be due to these bushings ??
@@catalincata5464 Hello, Not for sure to diagnost over the internet :) but mostly when those bushings are bad the wheel can move forward, when starting to accelerate and moves a lttle back when braking. Basically some glunking noise and not stiff steering can occure.
After reading haynes manual instructions and watching other videos I was not looking forward to doing this job but after watching this video I couldn't wait to get started. Jobs a goodin all sorted now 👍 Thank you 🤝
Dude this video is excellent… no talking, no tool lists, everything is sped up and it just shows you what to do… the chipmunk’d voice bites are an Easter egg
I agree, the usual 20 minute intro of why they haven’t uploaded lately, and why the camera angle isn’t good ect ect ect gets really old when you just need to see 30 seconds of how something comes off…
@@BraydenSZ exactly... when your hands are covered in oil and you're aleady frustrated from the job you just think f**k your ten minute ad-money
Perfect video! Got my new bushings delivered last night. Definitely ready to slap em in after watching this! Thanks for sharing
I like that floor jack. A very handy bit of kit.
You mean the old one with threaded system. Some legacy from old times :) but works brilliantly.
Wished I saw this before hand. I had to drop the steering rack 😢 then do the bolt blocked by the transmission. I m an idiot lol saves a lot of time
If you remove the bottom engine brace you can swing the engine forward enough to clear the bolt.
nice vid, st8 to the point, love the channel
So much wrong here, don't do this kids, follow torque procedures and use new bolts
What is the typical problem if the control arm bushing is bad?
Hi. Basically too much flex on front wheel when hitting the gas or brake. Clunking nois when sudden stop and also exessive tire wear.
New screws are important
Are they both the same?? Or does left and right matter?
I think they were same. Just rotated for the different side.
@@garageproductions359 thank you 🙏
At low speed, my steering wheel shakes and pulls a little to the left, the wheels are balanced and the running angle is done, it may be due to these bushings ??
@@catalincata5464 Hello, Not for sure to diagnost over the internet :) but mostly when those bushings are bad the wheel can move forward, when starting to accelerate and moves a lttle back when braking. Basically some glunking noise and not stiff steering can occure.
@@garageproductions359I hear it too at my car
what spray is that?
Hello. Just some random universal oil/lube spry, what was available at garage at that time. Could have been even some chain oil for bikes.