I have a video on the carby swap on my channel also! I'm running a Weber 34ADM, it is far simpler, easier to tune, and in my opinion just better then the original unit.
@Juan Cuenca either put a big Holley in, or spend the $ 1200 on a Holley Sniper, it's a bolt on carby with a fuel injector inside. From what I understand very easy to install, and can take big power via a blow through turbo setup. Simpler than getting an EFI motor which isnt that much better than the carby one
Do you think you could do a cam swap without taking the whole engine out?
What else is involved
@nk0723 its possible, but way easier with the motor out, and id highly recommended doing cam bearings while in there
What Carby you running.. if not the standard one.. any improvement
I have a video on the carby swap on my channel also! I'm running a Weber 34ADM, it is far simpler, easier to tune, and in my opinion just better then the original unit.
I want install turbo in this motor i have a 1998 Y61 same motor w/carby. Any idea? Sorry for My Bad English
@@juancuenca137 I am also wanting to do the same hopefully he gives us an idea👌👍
@@juancuenca137 turbocharging a motor with a carby setup like this isn't easy, it would be easier to convert to efi and then turbo it
@Juan Cuenca either put a big Holley in, or spend the $ 1200 on a Holley Sniper, it's a bolt on carby with a fuel injector inside.
From what I understand very easy to install, and can take big power via a blow through turbo setup. Simpler than getting an EFI motor which isnt that much better than the carby one
Does it get better or nothing changed
says it all in the video