![Omar's car parts replacement's + more](/img/default-banner.jpg)
- Видео 35
- Просмотров 425 392
Omar's car parts replacement's + more
Добавлен 7 окт 2015
2013 dodge challanger
Door latch malefunction quick fix, driver door outter doorlatch wont open the door, simple fix unless repair is required.
Просмотров: 14
Видео
2014 Ford Edge Starting
Просмотров 501Год назад
2014 Ford Edge starting issues. Apparently it seemed to Have a bad starter until I found out that the key was the problem . Don't waste your money check your key first.
How too replace 2001honda CRV idle air control valve
Просмотров 39 тыс.4 года назад
How too replace 2001honda CRV idle air control valve
How too go fromYellow too clear headlights
Просмотров 824 года назад
How too go fromYellow too clear headlights
2013 Audi A4 Quattro Ambient temperature sensor
Просмотров 16 тыс.4 года назад
2013 Audi A4 Quattro Ambient temperature sensor
2008 land rover lr3 v8 hse rear airbags+ strut replacement
Просмотров 1,7 тыс.4 года назад
2008 land rover lr3 v8 hse rear airbags strut replacement
2013 Mercedes c250 High Pressure Fuel pump installation.
Просмотров 44 тыс.4 года назад
2013 Mercedes c250 High Pressure Fuel pump installation.
Part 2 2013 Mercedes c250 High Pressure Fuel pump installation.
Просмотров 8 тыс.4 года назад
Part 2 2013 Mercedes c250 High Pressure Fuel pump installation.
2013-4 Ford edge headlight replacement
Просмотров 28 тыс.4 года назад
2013-4 Ford edge headlight replacement
2013 Hyundai Veloster turbo right upper engine mount replacement
Просмотров 4,7 тыс.4 года назад
2013 Hyundai Veloster turbo right upper engine mount replacement
How to replace 2015 Nissan Altima SV rear wheel bearing
Просмотров 14 тыс.5 лет назад
How to replace 2015 Nissan Altima SV rear wheel bearing
How to replace passenger upper right motor mount 2013 explorer xlt
Просмотров 21 тыс.5 лет назад
How to replace passenger upper right motor mount 2013 explorer xlt
How too replace lower control arms on 2014 Chrysler 300c hemi.
Просмотров 9 тыс.5 лет назад
How too replace lower control arms on 2014 Chrysler 300c hemi.
How too reset your engine oil, brake lights, and service after youve done a tune up, on BMW 535i 11
Просмотров 235 лет назад
How too reset your engine oil, brake lights, and service after youve done a tune up, on BMW 535i 11
How to remove and clean throttle body, on 2010 to 2013 camaro, on rough idle
Просмотров 43 тыс.5 лет назад
How to remove and clean throttle body, on 2010 to 2013 camaro, on rough idle
How to replace or locate crankshaft sensor on 10,11,(12),13,14 chevy traverse 3.6l awd
Просмотров 59 тыс.5 лет назад
How to replace or locate crankshaft sensor on 10,11,(12),13,14 chevy traverse 3.6l awd
How to replace motor mounts on 11,12,13,14, buick enclave, chevy traverse, saturn outlook and acadia
Просмотров 27 тыс.5 лет назад
How to replace motor mounts on 11,12,13,14, buick enclave, chevy traverse, saturn outlook and acadia
How too replace thermostat housing 2013 ford fusion 1.6l EcoBoost
Просмотров 60 тыс.5 лет назад
How too replace thermostat housing 2013 ford fusion 1.6l EcoBoost
How too replace turbo bypass solenoid 2013 ford fusion EcoBoost 1.6l turbo
Просмотров 36 тыс.5 лет назад
How too replace turbo bypass solenoid 2013 ford fusion EcoBoost 1.6l turbo
05 06 07 08 jeep Grand Cherokee 3.7L Upper Control Arm replacement
Просмотров 4,5 тыс.5 лет назад
05 06 07 08 jeep Grand Cherokee 3.7L Upper Control Arm replacement
On the squeeze clamps use zip tie use plyers first then put the sip tie on while squeezing
Hello did you have to loosen ac compressor to get to the bottom bolts of the thermostat housing??
You should call this video "installing the air intake manifold" You have the wrong title for your video.
What a pitty you did this video missing the most interesting parts in fixing this common problem of Mercedes C class especially . The most interesting part is how you remove everything and how you install it back not forgetting to rotate the crankshaft to the 52°mark .
Thanks, brother! Huge help!
Thank you!
But I don’t know why it didn’t start when I was gonna go home from work, then hit buttom of gas tank and start rite up too
I try to solve my 99 crv because motor quites on me whenever it wants to, serveral options for me either replace ignition switch harness or fuel pump relay, or distributor, dig into coil pack, I switch distributor from my 01 crv still rite up, looking into RUclips a guy replaced fuel pump relay so I did and start rite up
Fuel’s not gonna squirt out
I don't recall fuel squirting. But if so it shouldn't be too much
You talk way too much. Just get to showing the mechanics
I ma so 😔 sorry, just mute me thanks for watching bless you
Can the ambient air temp sensor throw a check engine light?
Thsnk you s.r
Used your video today, thanks very much!
Glad too read this. Thank you
Thank you!!!
My spring is In the way of the bolt on the right side how to get it out
Pull the mud flap off qnd use a wrench on one end and use a rachet on the other end. Let me know if you got it off.
$50 amazon
🤔🤔🤔🤔🤔 Its been a long time since this video. Refresh my brain please. Lol
Bro you are way over using that cleaner !
Its never too much lol. But i know lol i just love the way it works and the smell lol. Thanks for watching
i have a P1508 code (iacv circuit malfunction) however my 01 AT cr-v idles perfectly fine. i replaced the IACV twice and the car is idling as you described if it were broken (code stays). when i put the original old one on it idles normal again. any thoughts?
ummm.... yea.....all that needs to be removed is the air box, lol. The ecu gets moved over a bit, but can stay connected. Takes less than an hour.
Based on the dash and radio, that's not a 2014 Ford edge.
Q se debe que el mismo.eje trasero uno compensa 50% menos que el otro, ambos suben la misma altura
Creo deven suvir al la misma altura. Si no, va a quedar desanivelada la camioneta.
@@omarlopez-eb2nd si suben igual pero no sé si es que se daña el comñensador, aparte demás bolsa de aire
@@iglesiacasadejose6137 el compressor de se daña solo si no corta, se sovre calienta. Pero igual tiene unos tipo aniveladores que se atoran cuando no suve bien la bolsa. Ahi replasos de amartiguadores fijos. Solo que es un poco dificil de instalar.
@@omarlopez-eb2nd gracias por responder, la consulta es si el compensador se daña aún cuando las bolsas están bien, si funciona aparte de las alturas
Was trying to diagnose my crvs rpm flutter at idle and was trying to figure out where to start in fixing the issue, this just pointed me in the right direction. Thanks!
Hopefully it works for you boss.
Can the pump be repaired?
I've heard that repaired will only last a shorter time, but it depends who you send it to.
Is there a reparation kit available? is there a video how to repair? parts?@@omarlopez-eb2nd
@@jaimemarun2841 hmmm im not sure i would have to check on that. I will ask a repair guy and ill get back at ya soon
Thank you @@omarlopez-eb2nd
@@jaimemarun2841 well there is no kit to repair here in the valley texas. Amd it is best to replace with new hpfp, unless you want to pay again for a refurbished one that will most likely break again sooner than later.
Thanks Omar sure is a lot of work just to change a thermostat.
That was awesome man. Really helpful.
Thanks for watching
Can you do one motor mount at a time or do have to loosen bolts on all of them before jacking up the motor when replacing them all. I have a 2010 gmc acadia with bad transmission mount but figuring rest are probably bad as well. Thinking about trying to this my self. Will be doing it with jacks and jack stands on my garage floor. Thanks
Check them first. They say its best to replace all. But if the others are good , no need too replace. Loosen them first but dont remove them untill yoi jack the engine up first.
Just fyi the one you put on is for the 2.0L engine not the 1.6 like the one you pulled off. Good video tho
Did you have to drain all the coolant?
No i just refilled it as needed, then bleed the air out, wich took forever lol. Bit of a pain those engines
@omarlopez-eb2nd yea thank God it's been good. It's my daughters car so I'm doing my best to make it right. It has a small leak from the housing so I'm replacing that and the valve that bolts to it as well. I see a video and a few mechanics local are saying I can get to it with just removing the alternator so I'm starting that route first.
@@rafaelvillanueva7403 best of luck on your job brother
Can you use a manual transmission IAC valve on a automatic ? The price difference between the two is like $100 more for the auto vs the manual. They both look exactly the same part though. I am trying to replace for 1999 Honda CRV EX AWD 2.0L. Also is yours automatic and do you have link to the new part you used? At all Autoparts stores Advanced Auto Parts, Orielly's, and AutoZone it is $257 or so for the automatic tranny one and like $158 for the manual tranny one. I don't get why the price difference is so much!
Im not sure on that bro. But i think the part came from RockAuto.com. Quality parts and replacements. Just have to decide if you want to wait on the part to arrive. But if the part look ls the same and says on the description that it fits your car, only then you should buy. Check out RockAuto.com. look at the prices to see wich is convinient for you.
@@omarlopez-eb2nd Thanks bro and great video!
You had me on you can wriggle it 😏 New sun here 😃👍 Anyways I'm here because I'm having this issue. I will replace both motor mounts but I will be replacing thee entire front suspension to the last 🔩 bolts. I have all CV axels and hub assembly.
The plug has been rigged to fit that's why it didn't have the proper ends
I figured lol. 😂 i remember i had to get the pig tails from a junkyard to make it work lol
And how exactly did you get thar bolt out with shock tower in the way?
There is a washer nut on the other side, i think i removed the undercover to access that one washer using a wrench.
Thanks for the great information ❤❤❤❤
Great info. Thanks for making a video on this replacement.
I have the exact car like yours.. Same year,,same mark,,same model,,same size,,same everything Last time I changed the bypass housing hose with the temperature sensor cause of leaking coolant by the engine was overheating.. And it's still overheating of missing water coolant.. I didn't check the thermostat yet
If you havent done so. Call ford dealership and give them your vin, you might have some recalls. This particular model is something els
My Honda 2001 is P1508 actual Idle Air Control Valve Circuit ???
Great video gonna go do this job in the morning. Thanks bro
Where did you buy your part what brand
You didnt do this correct the idle is hanging after you blip the throttle
Amigo gracias burn video le puse uno ala mia pero travajo por 1 año empeso aser lo mismo pero ahora motor suve y vaja y cuando le doy gasoline Como que no quiere correl vien y nose si el muffler sale asy pero sale in Valentin Como si fuera candela no sera el catalist tapado dinde lo comoraste el idle gracias
🤮👎
The car repair is vomitiable or what happened
I just replaced the iacv and now the idles jumping up and down between 1 and 2 rpms in a steady rhythm now. What should I do? Put the old one back on?
I just had a low idle issues before hand. And so I thought I should replace it and I did. And now it has a jumping idle between 1 and 2. What’s the issue?
I think it is because I got a cheap eBay aftermarket one. I can’t get rid of the problem. I have put back the old one and it now is back to the low idle like almost wants to die but doesn’t. I will be looking for one at a junkyard now another day
thx bro really helpful
You didn't show what do to do about the 2 conconetors
where does it belong though? Just sits in the bumper? does it have a place to clip it out of the way?
Is the front the same?
Its a slight diferent rotor. But it's the same process, if that's what you qre referring too. The bearring should be a bit more challenging, being that you will need too remove the cv axle nut amd push in the cv axel with a rubber mallet, that way you dont hurt/strip the grooves on the axle. Good luck let me know your outcome.
Hello, what happens if the car still has those slow start issues, is it normal for it to strat with so little RPMs? what should I look next
Look into the spark plugs aswell the. Throttle body. Sorry for a 3week latwe response.
Because the sensor you keep pointing to is the knock sensor the crank sensor is to the left on the insulated wire
Useful video, sir what Auto parts did you buy your headlight assembly? Thank you!
Why would you post this!
Whats wrong with i?