Видео

Thank you

Easy to assemble. Bottle of Oil comes with it. Just did it in an hour with my son. Nothing special to assemble

Thank you for making this video. The direction that came with the tiller was terrible. I do not know if I could have put it together without it or at least it would have taken me a lot longer. Thanks again.

What size drive belt is this, I cannot find any accurate information in the manual and ardisam has it discontinued with no substitute suggested?

Can i retro fit this onto my older earth auger?

Worst assembly of my life! Should have listened to the reviews. Takeaways for you all: *Tiller blades: 1. Ignore sticker positioning other than know that all arrows need to point fwd in front of machine 2. Do not assume your pairs come together as a correct pair! I finally figured out that was my problem when the holes were too small to put the m10 bolt through. Small holes go inside, all arrows fwd, and long end till pieces are on the outsides. Follow those instructions and theres only 1 way it all works! 3. note if you want a smaller tilling base you should look further in the book for orientation before wasting your time now! Why it tells you that at the end i have no idea. *Sitting the engine on the wheel base was very difficult as stated by others! Took 2 people and a hammer to one of the bolts to finally get it. *belt cover part of the engine is horribly undersized. Bottom is not flush at all with all 4 screws attached Will definitely allow dirt inside from the bottom over time! I have yet to test this machine but i hope it was worth this 3 hour headache!

Second year in a row mine has been down for over 2 months waiting for a part. My first one was replaced because I had to wait the entire mowing season waiting on a part. the new one lasted about 15 hours this year before breaking down. All 4 pulley guide bolts sheared off again, bought 4 grade 8 bolts to replace them, two of the sheared off when the wheel fell off, the belt broke and the turnbuckle loosened up and the blades quit cutting. I do not recommend this to anyone, piece of garbage in my opinion.

Second year in a row that mine has been stuck in the shop waiting on a part for over 2 months. Lousy customer service, haven't heard from them since I reported the thing shearing the 4 pulley guide bolts, the belt breaking and the wheel falling off. Do not recommend this thing.

Rs

This Earthquake String Trimmer delivers impressive performance with its powerful motor and durable build. It excels in cutting through tough grass and weeds. Overall, it's a solid choice for maintaining a well-manicured lawn with minimal hassle.

That big Acreage rough cut mower will sure take down an impressive amount of brush/grass/weeds. Powerful!

Great products! The string mower is one of my personal favorites. Easy to operate and fun to use! Mows down everything in its path.

The Proper belt size is 26" O.D. the AX24 is the replacement I used yesterday to fix my tiller.

I have the older model, too! It must be great to only work on factory-new machines! This video is totally useless to me!

I have yet to see a job done by a walk-behind edger that couldn't have been done nicer, faster, and easier by a stick edger.

Thank you so much 😊

This looks exactly like the Toro tiller. Are they same thing with just different stickers on them.

What size of small trees will it cut. Will it cut 1/4”-3/8” trees off a driveway?

Good luck taking the blade off this pos when its worn down. Been fing with it for hours and the manual is worthless

I've had mine since 2015 with no issues or problems. I preform regular maintenance every year & replaced a clutch cable. Still starts everytime. I'm a 70 yo woman so it's just now getting abit much for me to push around, but it starts for me.

I wish the video showed how to put oil in as well as start up.. You guys assume we know to keep it level and pour oil into the little oil plug. 🤷🏻‍♂️ oil was dripping everywhere since there’s no directions anywhere. It took me like 15 minutes looking where to put oil.. didn’t know it was pour right into dipstick plug.

Also I wish they labeled the bolts.. it’s a guessing game

Following but the arrows, one is showing and one of on opposite side.. going in Same direction

gonna try this one - D&D PowerDrive AX25 V Belt, AX, Rubber, 1/2" x 27" OC

Considering there is a need for a shield in front of the electrical..I blew a belt and took out the relay and wires...

How can I get one

How much is it

Palm tree fronds are a nemesis for any shredder.

I have this mower, and I like it. But I need to clean the engine. The manual doesn't say how to do it and this is the only video about the mower on this channel. Why don't you post maintenace videos? I'm sure I'm not the only one that could use them.

Lot of good that did… no hammer replacement??

How do I replace the pull string

How do I replace the pull string

Mine line cutter assembly broke ordered a replacement 3 months ago hasn’t arrive yet, so I ordered it from Amazon , the problem is it didn’t come with a head shaft. And original one does not disassemble from the shaft so what can I do? Can’t order one from Amazon

How can you tighten your belt

Anyone or Earthquake have the part numbers of the forward and reverse cables both of mine is broken and I need to replace them

How do I take the engine apart? I think I may have a broken push rod.

Great video. But could you do one on how to change the oil? Specifically, how to remove the left tine guard. Do you have to remove the wheels first?

did you fix all the issues you were having with this mower (belts etc) i wanted to buy one this week but you reviews everywere are not good

thank fuk i seen this video...i was about to buy one

How to take spark plug out

How to remove spark plug in earthquake tiller

Have the old model too... they no longer sell the tri and j hammers... figyers... i love this thing, starts easier than anything ive ever owned... i guess ill run it to its grave...

So what is the problem with these front drive belts, when I broke mine I tried to get another belt but they said they were all out because so many front drive belts had broke that they had no more in stock. If it is a safety precaution to snap the belt before something more major go's wrong. Or did they make the pulley's to narrow and should have a larger belt, because it seems these belts are snapping very regular. I live in an isolated area and I wasn't able to get a belt sent to me and I was not able to do my garden last fall. When it was working it did a great job, up until the belt went out, and I live in Canada and I am still having a hard time getting this belt, because they do not ship from the U.S. so now I am looking for any belt the same size.

Does this work with other brands like sportsman

How do I figure out what size of belt do I need

How to figure out what size i need

Will this have powered wheels but stopped tines whed going across the lawn?

It would be nice to have instructions such as metric or standard, what size socket and wrench. Please EDIT. I have one coming Monday. What about adding oil, do I need a long funnel?

Got part numbers and a way to order the replacement blades?

Wow, putting that together was fun, said no one ever. At least this video made it easier than the instruction manual