Brief description about NX Advanced Simulation, model prepearing, pre-processing, solution and post processing. For more information, check out www.turamuhendislik.com
Your video has been very helpful. I have a question about symmetry condition. You put 10N load on the surface after symmetry option. Is 10N a half of full load on full modeling? If no symmetry option, should 20N be loaded?
I know this is months ago, but he cuts the assembly in half an applies a symmetry condition along the cutting plane in order to reduce run time but get the same results
Your video has been very helpful.
I have a question about symmetry condition. You put 10N load on the surface after symmetry option.
Is 10N a half of full load on full modeling? If no symmetry option, should 20N be loaded?
can i know how to do this when i am doing drilling or milling because i want to get the time taken to create the parts
why are you cutting (splitting) this assembly!?
I know this is months ago, but he cuts the assembly in half an applies a symmetry condition along the cutting plane in order to reduce run time but get the same results
is there any command that enables section view WITH the sim results, because after I run the sim and cut the model, it just shows one colour section?
merhaba
maraba