Siemens NX 10 - Fluid/Thermal Analysis - Advanced Simulation Mode

Siemens NX 10 - Fluid/Thermal Analysis in Advanced Simulation Mode of an Exhaust Pipe.

[@AdityaKadamMechanical]

Very helpful, thank you Sir!

[@antonioinochi9170]

Dear Derick, can you give us some advice regarding the simulation about a vertical axis wind turbine? i would like to know the best shape to optimize the performance when there is a low wind. Thanks. Best regards.

[@omarocampo7189]

Using any of these methods can I know if a design could blow at a determined gas pressure?

[@avula.vishnuvardhanvishnu5665]

in nx ug extusion dies simulaion is possible