Concrete Patch V: How to Repair Damage Due to Slab Leakage Waterproofing Problem
HTML-код
- Опубликовано: 13 дек 2021
- Ordinary concrete mix cannot repair the concrete spalling on your ceiling. Aside from its lack of strength, an ordinary concrete mix can’t be used for overhead applications. Remember: the repair mortar should be stronger than the substrate.
Also, without non-sag properties or formworks, the repair mortar will just eventually drop on the ground. The tendency of ordinary concrete mixes to shrink also poses a big problem.
So, what should you do if your ceiling just suffered from concrete spalling?
First, you have to check the slab leakage or if there's a slab roof waterproofing problem.
Concrete Patch V is a cementitious, pre-packed repair mortar with shrinkage compensation properties. It can achieve up to 5800psi compressive strength at 28 days. It allows vertical and overhead application of a 40mm single-layer patch without using formworks.
🛒 Shop Online:
Concrete Patch V - bit.ly/3Dep0uE
Rust Converter - bit.ly/3DIG4bZ
Epoxy Primer - bit.ly/3yeaNMJ
Confix HV - bit.ly/3GxgMPS
🔨 Buy on Depots: bit.ly/3wgvEhD
☎️ Call Us: 0905 479 3992 / 09054793991 / 09054794008
📧 Email Us: customerservice@magnaprime.com.ph
🎞 RUclips Channel: bit.ly/3dG4Uja
🌐 Visit Our Website: www.magnaprime.com.ph/
📱 Join Our Viber: bit.ly/3gZGjXN
#Concretespalling #MagtanongParaSigurado #ConcreteRepair
thank you for your patience. we are now in the process of waterproofing our roof deck and repairing spalled ceiling, and we are using exclusively buildrite materials, so i really need your technical expertise.
Thank you for supporting Buildrite. For further information, you may contact Engr. Jay Ian Kert Millena at 09054793992.
do i need to apply confix hv in between layers? also, do i need to scarify the surface of an already applied layer in preparation for the next layer?
Hi. Thank you for your inquiry. Using a trowel, Concrete Patch V can be applied up to a thickness of 40mm. It is essential to build up to this thickness in consecutive layers of 10 - 15mm using a “wet on wet” technique to ensure maximum compaction and substrate adhesion. No need to apply Confix HV as long as Concrete Patch V is still wet.
another question: can i use confix hv for tile to tile adhesion?
Hi. Thank you for your inquiry. For tile over tile application, we recommend Buildrite's Cement grip and Smartbond tile adhesive. You can see this post for your reference: facebook.com/BuildritePhils/photos/a.256515081150962/2275577692578014/
...but how does it not fall from the ceiling? Does one slide a sheet of plywood from one side to the other filling the cavity sideways as you go?
Hi, thank you for your inquiry. Concrete Patch V is a non-sag repair mortar for verttical and overhead application.
CONCRETE PATCH V can be applied up to a vertical thickness of 40mm. However, it is essential to build up to this thickness in consecutive layers of 10 - 15mm using a “wet on wet” technique to ensure maximum compaction and substrate adhesion. Thickness is dependent on the substrate profile. Sagging will occur if the applied layer is too thick. If sagging occurs, the material should be completely removed and re-applied at a reduced thickness. The surface, however, should be scarified to provide a mechanical key for subsequent layers.
Sir mai ek ghr khareed Raha hu, usme bathroom me same aise hi lenter gir ra hai aur saria bhi, kya vo repair ho sakta hai, aur ha to please kisi engineer ka number share karo.
Confic hv is too sticky to apply wirh ease with a brush Can I use a thinner to make it less so? What do you recommend as thinner if any?
Hi. Thank you for your inquiry. No thinning required for Confix HV. Its consistency is ideal for overhead and vertical application to avoid sagging. If you need a low viscous bonding agent, we recommend Buildrite's Confix LV. You can watch this video for your reference: ruclips.net/video/dPsfJAHqvEY/видео.html
Sir what if the depth ig the spalled portion exceeds 40mm? Is it still advisable to fill in that depth with patch v? Csn I use concrete grip to apply the layer that comes after the initiall 40mm patch v?
Hi. Thank you for your inquiry. If the spalled portion is more than 40mm, you have to let it cure first. After setting, you can now apply another layer of Confix HV and Concrete Patch V.
Thank you for the Idea, so where can I buy your products???
Hi.Thank you for your inquiry.Good day! You can order online via our Magna Prime Shop (bit.ly/3D8vqLx) or our official Lazada and Shopee shop (s.lazada.com.ph/s.fFwNe) or buy from our partner depots near you (bit.ly/3PKbnZW)
we are trying to patch the spalled ceiling by patching 10mm per layer of concrete patch v until we reach the desired thickness. will it help to use concrete grip in between 10mm layers to improve adhesion of one layer to another? also, will it help to mix patch v with concrete grip?
CONCRETE PATCH V is a cementitious pre-packed repair mortar with shrinkage compensation properties. It is supplied as a single component powder which only needs mixing with specific quantity of water to produce a non-shrink mortar allowing vertical application of 40mm thickness in a single layer without the use of formwork.
Hello pwede po ba pamalit ang product na Cement Grip sa Confix HV?
Hi, thank you for your inquiry. No, we recommend using Confix HV as bonding agent for Concrete Patch V. It is a non-sagging epoxy adhesive perfect for vertical and overhead use.
Mmm that could be solution for the concrete resistance aspect but what about the steel for ductility of the structure or the posible waterproof necessary for the corrosion?
Hi, thank you for your inquiry. We recommend consulting with a structural engineer first to check if the structure can still be repaired using the product. Waterproofing the positive side of the area is also a must to ensure that the problem will not re-occur.
how long is the ideal curing time?
Hi. Thank you for your inquiry. If the spalled portion is more than 40mm, you have to let it cure first. After at least 8 hours, you can now apply another layer of Confix HV and Concrete Patch V.
Hi, may I ask lang pala kasi it just so happens na na expose din ng ganyan yung metal bars nung kisame namin dahil sa continuous na ulan netong mga nakaraang araw, tapos yung isang bar naputol pero nakakabit pa din, can I use this as a temporary solution muna?
Hi, thank you for your inquiry. The first thing that you need to do is to apply a waterproofing materials on the positive side of the slab to avoid this happening again. Proper assessment and surface preparation is needed prior to its application. Message us on our Facebook page for more information (facebook.com/BuildritePhils). Visit our website at (www.magnaprime.com.ph). Join our Viber Community at (bit.ly/3gZGjXN)
Are these products available in the United States? Thanks
Good day! Unfortunately, Buildrite products are available in the Philippines only.
Sir paano po b ang pag aapply ng concrete patch v , layer by layer po b, o pedeng ifill agad yung area na hindi muna pinapatuyo yung unang pahid?
Concrete Patch V can be applied up to a vertical thickness of 40mm. However, it is essential to build up to this thickness in consecutive layers of 10-15mm.
Thank you for the video.sir where can we buy these materials cause we have a problem too,on spalled ceilings .Sana po we can buy these while explaining sa gages how to use it.
Hi, you can order online via our Magna Prime Shop (bit.ly/3D8vqLx), official Lazada and Shopee shop (s.lazada.com.ph/s.fFwNe) or you may send to us your exact address via our Facebook page for us to assist you in locating the nearest store in your area: facebook.com/BuildritePhils
Sir, how do you apply this material? Pahagis ba na gaya ng semento o pwedeng papahid lang na parang masilya? looking forward to yor reply/ thank you.
You can apply it with steel trowel same with application of patching holes.
Good day ganun din po ba ang proseso kung ang beam naman ang may ganyang problema?
Yes, same process.
Sir pwede bang yung Leak Plug ang pang patch, pang palit sa CONFIX V. Thank you
Hi, thank you for your inquiry. No, ma'am. Concrete Patch V is a non-sag repair mortar that can be used for overhead and vertical applications while Leak plug is a rapid setting mortar for plugging leaks on running water and for waterproofing purposes on corner joints.
pwede na ba pinturahan agad ang patch v pagkatapos ng repair? o kailangan pa ba maghintay ng 28 days to alllow full curing bago pinturahan?
Hi. Thank you for your inquiry. Yes, at least 28 days curing prior to the application of paint.
Malakas rin po ba ang tensile strength ng Confix HV? Say fully corroded na yung bakal ng slab, tapos sa gitnang portion pa ang location which is maximum yung tensile stress, kaya po ba ng ganyang method ang pag rehabilitate?
Hi, thank you for your inquiry. We suggest to have a consultation with a licensed structural engineer first before using this method of repair.
Saan nabibili ang concrete patch v or ano ang pwedeng alternative pag wala
Hi, you can order online via our Magna Prime Shop (bit.ly/3D8vqLx), official Lazada and Shopee shop (s.lazada.com.ph/s.fFwNe) or you may send to us your exact address via our Facebook page for us to assist you in locating the nearest store in your area: facebook.com/BuildritePhils
Good day sir Tan. How about naman po sa slab ng crack and damages before i apply patch V ano po recommend nyo confix LV or Confix HV?
Hi.Thank you for your inquiry.Confix Hv po sir ang bonding agent ng concrete patch v.
@@BUILDRITECONSTRUCTIONCHEMICALS And okay lang po ba na medyo wet pa ang confix HV betore ko po i apply si patch V?
@@BUILDRITECONSTRUCTIONCHEMICALS Ano din po and recommended nyo to apply si confix HV? P-brush or Paleta like spatula?
It should be applied using a wet-on-wet application. You can use a brush or spatula to apply Confix HV on the substrate.
@@BUILDRITECONSTRUCTIONCHEMICALS Good day again sir tan if i apply patch V hahaluan po ba ito ng binista or hindi na po thanks.
Saan ba makabili buildrite products Dito sa bohol
Hi, Thank you for your inquiry. Selected Buildrite products are available at Packman Enterprises located in Totolan, Bayan ng Dauis, 6339 Lalawigan ng Bohol.
How about damaged concrete rebar? Do we need to replace it?
Hi, thank you for your inquiry. Depende po ito, sir. First, we recommend na ipa-check muna sa structural engineer. Sila po ang makakapag sabi ng tamang methodology.
Mga Sir, saan sa pangasinan makahanap ng mga product nyo po,. Salamat,,,
Good day! You can order online via our Magna Prime Shop (bit.ly/3D8vqLx) or our Lazada and Shopee shop or buy from our partner depots near you (bit.ly/3mo43WZ)
Sir, applicable parin po ba itong solution sa sobrang kinalawang na bakal sa slab and yung yung slab is more than 15yrs na? Thank you
Hi. You can message us through our official Facebook page facebook.com/BuildritePhils for us to assist you further regarding your query. Thank you
Sir jay ar? Same scenario po tau paano po ginawa nyong diskarte? Halos putok na ung bakal ng slab
Ilang psi strength po ang concrete patch v?
Hi, thank you for your inquiry. Its 5,800 psi at 28 days.
How to get this in India?
Hi, thank you for your interest in our products. For now, we can only offer deliveries of our products within the Philippines nationwide, but we are looking forward to supplying our products internationally in the future.
location po? nagseservice po ba kayo ng ganyang situation? ty
Hi, thank you for your inquiry. Yes, for supply and application services, please message us on our Facebook page: facebook.com/BuildritePhils
Can I use this method even if the rebars are not exposed, only concrete nag babakbak
Hi, thank you for your inquiry. Concrete Patch V can be applied on a minimum thickness of 10mm.
So all I need is confix HV and concrete patch V?
Kindly send pictures of the actual area on our Facebook page so we can assess the area: facebook.com/BuildritePhils
Sir available po yong product sa depot store
Hi, you can order online via our Magna Prime Shop (bit.ly/3D8vqLx), official Lazada and Shopee shop (s.lazada.com.ph/s.fFwNe) or you may send to us your exact address via our Facebook page for us to assist you in locating the nearest store in your area: facebook.com/BuildritePhils
Wer can i buy buildrite materials?
Good day! You can order online via our Magna Prime Shop (bit.ly/3D8vqLx) or our official Lazada and Shopee shop (s.lazada.com.ph/s.16hV8) or buy from our partner depots near you (bit.ly/3mo43WZ)
Make a video with audio.
Thank you for your comment. We will surely consider this.
kailangan ba basain araw araw yung finished patch while waiting for it to fully cure for 28 days?
Hi. Thank you for your inquiry. In common with all cementitious materials, CONCRETE PATCH V must be cured immediately after finishing in accordance with good concrete practice. The use of curing compound (Buildrite CURESIL) sprayed or brushed into the surface is recommended.
Do i need to spray curesil every day for 28 days?@@BUILDRITECONSTRUCTIONCHEMICALS
No. Spray CURE SIL as evenly as possible over the freshly laid concrete as soon as possible when the surface water has disappeared.
Does this restore the structural integrity of the concrete
Hi.Thank you for your inquiry.Yes po sir.