BMW 2 Series - Rear Brakes Replace

In this video we show you how to replace rear discs and pads on a BMW 2 Series 2013
The following tools & material are required:-
- 17mm wheel nut socket
- 10mm socket
- 16mm socket
- 6mm allen
- 8mm allen
- Hammer
- Flat head Screwdriver/small pry bar
- Torque wrench ranging from 25Nm to 110Nm
- Wire brush
- Brake grease
- Brake cleaner
- DOT 4 brake fluid
- Brake pads
- Brake discs
Link to Brake bleeding video:-
• How To Bleed Your Brakes
DISCLAIMER
All work should be carried out by a competent professional and torque settings should be obtained from your own source.
Don't Forget to visit our website and online store!
www.dtb-performance.com

[@sawyerboy13]

Really wish you would say what year this is.

[@DropTheBoxOfficial]

2013

[@alexwarrener3770]

When adjusting the shoe, does the handbrake need to be on or off or does it not matter?

[@DropTheBoxOfficial]

Good question
Handbrake off when adjusting shoes

[@UsxrUnknxwn]

Did you have to compress the piston?? Is it a rotational or just pushed back

[@DropTheBoxOfficial]

@@UsxrUnknxwn push back

[@seanglossop4777]

I just attempted this on my 2 series. When I used the 8mm allen to try and remove the calliper pins (4:21) I was putting an extreme amount of force on them and they weren't budging - any tips? I didn't want to put WD40 on them in case that was the wrong type of thing to use

[@DropTheBoxOfficial]

Wd40 on the threads, work them in both directions. Could try applying a little bit of heat but be considerate of the rubber components around it.

[@seanglossop4777]

@DropTheBoxOfficial Great thanks for replying, will try tomorrow, otherwise I'll just get a garage to do it