Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
Well done guys!
The reason why at 46.20 the points are not automatically selected by the hole command is that you have two sketches visible. Must be only one.
What is the equation used to drive the hole pattern? Only part of it is visible during the example.
Why do you project the plane and not the axis?
Hi Mark,No reason in particular that I know of. The effect should be the same. So if you’d rather project the origin axis it would still be as good of a practices as projecting the workplanes. I personally have done both. -Javier Chavez
Well done guys!
The reason why at 46.20 the points are not automatically selected by the hole command is that you have two sketches visible. Must be only one.
What is the equation used to drive the hole pattern? Only part of it is visible during the example.
Why do you project the plane and not the axis?
Hi Mark,
No reason in particular that I know of. The effect should be the same. So if you’d rather project the origin axis it would still be as good of a practices as projecting the workplanes. I personally have done both.
-Javier Chavez