Peace, mercy and blessings of God be upon you. I am a new subscriber to your channel. Thank you for your hard work. Really great work from you. I wish you continuity and always enable the subtitle feature in the video because I speak Arabic. Thank you, your friend Omar Al-Rajeh from Syria
hi, how you do for your osciloscope probes don't have the ground wire to attach? do you have some video to teach that ? can you teach ? thanks . greetting from portugal ;)
I Now, if you have to, install the available parts and install any fuse or replace it by removing a single wire from any main wire and solder it and make a jumper, after that you will see the FET shored issues.It is also important to check what was the cause because the gate pin of the FET can be messed up with the PWM chip on top of it, so that chip needs to be replaced as well. Put two or three resistors in parallel to maintain the wattage of the R1 resistance using the available 2.2 ohms.
Peace, mercy and blessings of God be upon you. I am a new subscriber to your channel. Thank you for your hard work. Really great work from you. I wish you continuity and always enable the subtitle feature in the video because I speak Arabic. Thank you, your friend Omar Al-Rajeh from Syria
Big Thank ! I m learning soo many thing abt PlayStation repairing...
Great to hear!
hi, how you do for your osciloscope probes don't have the ground wire to attach? do you have some video to teach that ? can you teach ? thanks . greetting from portugal ;)
Yes I can
@@idreestechmany thanks 👍 can't wait for learning that... ;) Greatings from Portugal 🇵🇹 🌟
Nice wan boss
Thanks 🎉🎉 very much
Welcome
Ps4 power supply 0.16 ohm (160 milliohm) resistor fuse blown. I can find only 0.1ohm and 0.22ohm 1 watt resistor. Which is to be used?
Dear please more details about the issue.
@@idreestech mosfet and R1 0.16ohm resistor blown. Mosfet already replaced I buy. Fuse I can't find 0.16ohm. only 0.1ohm and 0.22 ohm available.
I Now, if you have to, install the available parts and install any fuse or replace it by removing a single wire from any main wire and solder it and make a jumper, after that you will see the FET shored issues.It is also important to check what was the cause because the gate pin of the FET can be messed up with the PWM chip on top of it, so that chip needs to be replaced as well. Put two or three resistors in parallel to maintain the wattage of the R1 resistance using the available 2.2 ohms.
@@idreestech ok. I will try
I have a ps4 slim it shuts down after 5 to 10 minutes of game play and the other one shuts down as soon as i launch a game. What could be the problem
Is the PSU original or a cloned one. If it is original try replacing new capacitors at 220 volts for filtering the bridge rectifier DC volts.
I have the same issue bro, did yours get fixed?