Thanks for the video. Just a thought......I know there were no leaks but you might consider practicing your brazing techniques. A little more heat would help with the cold welds.
@@Joshuatimmons1783 the cut in and cut out on a freezer should be 0 and 15 psi,scrolls do not have reed valves,that is why there is a time delay on the condenser,it has been by passed,that is why it was short cycling.
@@MariosACandRefrigeration yeah I know that but that one has an inteligen controller which does defrost has the delay and controls the expansion valve it’s just turned off in the board
@@MariosACandRefrigeration heatcraft wants the time delay in condenser removed because of the time delay in the board. The compressor was probably short cycling because the superheat was wrong due to the probes being bad and the EXV being open just a few steps not letting the suction pressure build up enough
Change them all as set the sensor you know the saying one goes bad eventually they will all go bad great video.
👍👍👍
👍
Thanks for the video. Just a thought......I know there were no leaks but you might consider practicing your brazing techniques. A little more heat would help with the cold welds.
Absolutely. 👍 be been vocal about my problem of not getting her hot enough. Making ugly welds.
Would a time delay protect the compressor?
Wouldn’t do anything on the ones with a board because the board has one built in
@@Joshuatimmons1783 the cut in and cut out on a freezer should be 0 and 15 psi,scrolls do not have reed valves,that is why there is a time delay on the condenser,it has been by passed,that is why it was short cycling.
@@MariosACandRefrigeration yeah I know that but that one has an inteligen controller which does defrost has the delay and controls the expansion valve it’s just turned off in the board
@@MariosACandRefrigeration heatcraft wants the time delay in condenser removed because of the time delay in the board. The compressor was probably short cycling because the superheat was wrong due to the probes being bad and the EXV being open just a few steps not letting the suction pressure build up enough
@@TH17992 I think he should wait,the sensors never go bad.