I have a 05 fx35 these cars have the same trans and engine my bell housing cracked and had a big hole I found a bell housing on eBay wanted to know it it a had job do u have to remove the whole trans or is it possible just to swap out the bell housing
I have a problem with my infinity g35 and I hope you can help me with some information. One way or another water went into my gearbox and the car wouldn’t even go into gears. Then i got another gearbox from the nissan fuga and put it into my car with the fuga’s tcm. My car wouldn’t start with the push to start switch and when I did get it to start bij jumping the starter it would stay in high gears while driving. Now i put back the old tcm on the new gearbox I had to turn on the car to scan it and after clearing all the codes tha car started with the push to start switch and the car drove good. After a couple minutes of driving the gear indication on the dashboard started flickering and the car went back into a high gear. I have no idea what the problem is anymore. It would be much appreciated if you had some information that could help me
Is there anything during the transmission replacement procedure which would cause the gas pedal to be completely unresponsive after new tranny installed. Car goes into gear but no RPM increase at all when gas pedal pressed after tranny installed. Please help????
Авто/Мото
Looks like a pretty straightforward removal which makes it nice and by the look on his face I do believe he enjoyed a ride in the Camaro!!
I have a 05 fx35 these cars have the same trans and engine my bell housing cracked and had a big hole I found a bell housing on eBay wanted to know it it a had job do u have to remove the whole trans or is it possible just to swap out the bell housing
I have a problem with my infinity g35 and I hope you can help me with some information. One way or another water went into my gearbox and the car wouldn’t even go into gears. Then i got another gearbox from the nissan fuga and put it into my car with the fuga’s tcm. My car wouldn’t start with the push to start switch and when I did get it to start bij jumping the starter it would stay in high gears while driving. Now i put back the old tcm on the new gearbox I had to turn on the car to scan it and after clearing all the codes tha car started with the push to start switch and the car drove good. After a couple minutes of driving the gear indication on the dashboard started flickering and the car went back into a high gear. I have no idea what the problem is anymore. It would be much appreciated if you had some information that could help me
That G35 owner is probably at the Chevy dealer today buying a Camaro SS.
Everyone needs one!
That ending was the best!
He had a blast!
How many transmission mounts does a 08 g35 have? I have one as well but I don’t know if it’s only one or two.
Nothin like a rowdy V8 to make you laugh like a kid again!
If your not smiling your not alive!
I should have watched this first, thank you
Is there anything during the transmission replacement procedure which would cause the gas pedal to be completely unresponsive after new tranny installed. Car goes into gear but no RPM increase at all when gas pedal pressed after tranny installed. Please help????
Ground wire, something pinched, wires got disconnected.
Would the same steps be made for an automatic?
Not exactly, similar but you have a few differences.
@@slow_restoration please explain! i need to get a new trans of my 07 g35s sedan
how much does this usually cost?
Following
Is it the same with the auto?
No, similar but different steps.
@@slow_restoration do you happen to have a video to the auto trans by any chance
@@davidcabrera3201 I don't.