BRK Ghost Barrel Clamp Kit

As BRK introduces 24 and now 28 inch barrel kits, they are also adding an option to add tension to the mounting block with their BRK Ghost Barrel Clamp Kits. Check out this product and all the Performance Parts for Daystate and BRK here:
www.airgunsofa...

[@Crazyhorseracing461]

Just ordered a kit from you guys for my ghost, should be here today 👍👍👍

[@elvisjerrylee]

I am considering a barrel clamp kit for my Ghost 22cal HP.
Please give us your opinion on yours when you get it.....Thanks!

[@tc5427]

Thank you for the video. This "barrel tensioner system" confuses me. I have seen multiple variation of "how" to install it. 1. The treaded end piece on the end of the barrel is twisted to apply tension; it pulls the barrel against the grub screw at the feed port, thus putting stress on that grub screw connection, then they tighten the 6 grub screws on the sleeve..not really sure what that does at this point other than scratch your barrel. 2. First they tighten the 6 grub screw sleeve, then the twist the threaded piece at the end of the barrel. So now those 6 grub screws that are not seated into an indent in the barrel are supposed to resist the tension being applied. 3. This video's version, where tightening the grub screws applies "tension". They do no apply tension, they might effect the barrel harmonics but they don't apply tension. I am assuming that because AoA is a licensed distributor for BRK that this is the Official way BRK says to install the kit?

[@williamwilson2624]

Very nice!

[@DedekFaisal]

👍👍👍👍👍

[@masuntung643]

Keren sekali 😁👍👍

[@preyingmathis2517]

Hmmmm I wonder if the BRK Ghost is experiencing some poi issues like its dad... The Impact.