This video has answered all my queries...very simply demonstrated. I have the same problems with my Jonsered 2234 which is a similar saw... thanks a million.
I think you will agree that saw is running terrible. I recently repaired a 236e for a friend. He had already replaced carby, fuel lines and spark plug etc. Saw had plenty of compression and should have run. I checked spark which appeared week. After temp replacing coil pack I replaced the original 3 magnet flywheel with the 2 magnet flywheel off my Husqvarna 137 and completely changed saw into what it should be. This fix will cost about $20, hope this info helps
QUESTION .... MY 326 CHAINSAW has some fuel trouble I installed a new carbu. and it starts and stops could be the inlet line is to small 3 .5 Diameter the carburettor people provided me with both fuel lines one yellow and one black ---the old one is yellow --outlet 4.5 di and must have been white one the inlet ---- BOTH THE NEW ONE ARE 4.5 diam. to fit the new one to the petrol tank I should drill the hole out bigger probably 4.5dia (mm) In doing this operation could create any problem to the carb or its ok ?
Boa noite. E adaptei várias 236 com carburador das motosserra importadas .postei algum vídeos no RUclips.todas ficaram boas.infelismente a husqvarna errou nesse carburador.pois e uma máquina robusta com peças fortes. Parabéns pelo teu vídeo.um abraço que Deus te abençoe 😅
This video has answered all my queries...very simply demonstrated. I have the same problems with my Jonsered 2234 which is a similar saw... thanks a million.
I think you will agree that saw is running terrible. I recently repaired a 236e for a friend. He had already replaced carby, fuel lines and spark plug etc. Saw had plenty of compression and should have run. I checked spark which appeared week. After temp replacing coil pack I replaced the original 3 magnet flywheel with the 2 magnet flywheel off my Husqvarna 137 and completely changed saw into what it should be. This fix will cost about $20, hope this info helps
Block your carb with a paper towel to keep debris out while you work. Also, use carb or brake cleaner to clean up the linkages and carb itself.
Low side screw was in a bit to far. Lean stall when sitting(running out of fuel at idle)
QUESTION .... MY 326 CHAINSAW has some fuel trouble I installed a new carbu. and it starts and stops could be the inlet line is to small
3 .5 Diameter the carburettor people provided me with both fuel lines one yellow and one black ---the old one is yellow --outlet 4.5 di and must have
been white one the inlet ---- BOTH THE NEW ONE ARE 4.5 diam. to fit the new one to the petrol tank I should drill the hole out bigger probably 4.5dia (mm)
In doing this operation could create any problem to the carb or its ok ?
Boa noite. E adaptei várias 236 com carburador das motosserra importadas .postei algum vídeos no RUclips.todas ficaram boas.infelismente a husqvarna errou nesse carburador.pois e uma máquina robusta com peças fortes.
Parabéns pelo teu vídeo.um abraço que Deus te abençoe 😅
What are the inner and outer diameters of the fuel hose?
Can you give me a link to where I can purchase the fuel hose to check the specifications?
Do you find out the right pipe size OD ID?
The choke should disengage as soon as you pull the trigger, you shouldn't have to manually push it back in
It’s a t 25 and a t15 both you need not t20
Sort the sound out 🤣