How to fit a thermostat & heater element to Bosch, Neff or Siemens washing machine

Get your appliance fixed faster! Click the link below to browse our supplier's huge selection of appliance parts and support the channel at the same time! (repairpartstea...)
Tutorial: www.how-to-rep...
Washing machine not heating, We are going to show you how to fit the new element and thermostat to this Bosch, Neff or Siemens washing machine this process should be pretty similar to your make and model of front loading machine.
Safety first disconnect your washing machine from the power supply and it's a good idea to turn the washing machine water supply of.
1. Remove two screws from back of the top panel. These are normally torx head screws and you can get a full set of these torques bits in our tool section.
2. Take out the soap dispenser draw by pressing the button on top.
3. Remove front panel after removing screws, do keep these screws separate because they're stainless steel.
4. Remove the kick strip and pump flap normally one screw.
5. Remove this retaining clip which is holding the door seal against the machine. There are lots of different ways that these retaining clips work, see video.
6. Remove screws that are now holding the front panel of machine on.
7. Remove door interlock, two screws.
8. Peel back door seal after taking the retaining clip of. See video
9. The element is situated at the bottom of the drum. Take photo of the wiring before disconnecting it.
10. Just uncouple the wires attached to the thermostat. Usually block connector.
11. Undo this nut which is attached to the retaining clip, with a spanner or a socket. Don't undo it all the way because you have to tap the nut in, to release the pressure on the seal, then with a flat bade screw driver prise the washing machine heater element away from the outer tube. Be careful with this
12. The thermostat is a push fit into the element
13. If you need to check if the element has blown you will need to use a multi-meter to test it.
14. Replace which part is need and reverse this procedure
Please remember to subscribe to our channel
www.youtube.co...
Remember to Shop with www.how-to-repair.com and it would help us by posting the video or the website on your
timeline. This helps us a lot and if we really helped you can always buy us a beer how-to-
repair.com/help/buy-paul-a-beer/
Please remember to mark us to your favourites also I would be grateful if you would subscribe to our channels
social media as this really helps my site and keeps us going.
RUclips. / apart4u
Facebook. / how.to.repair.appliances