Sorry bad video I'm trying. Put one bushing in the control arm, Then send the shaft through the control arm side without a bushing the shaft must go in big washer side first install the big washer after you have sent it through the control arm. Now slide the small washer onto the shaft and install the bushing then add the sleeve and tighten the nuts add locktite. Thanks for watching! It was one of the first videos I shot some of my later stuff is better.
Sorry bad video I'm trying. Put one bushing in the control arm, Then send the shaft through the control arm side without a bushing the shaft must go in big washer side first install the big washer after you have sent it through the control arm. Now slide the small washer onto the shaft and install the bushing then add the sleeve and tighten the nuts add locktite. Thanks for watching! It was one of the first videos I shot some of my later stuff is better.
Awesome video. About to do this job next weekend and I've been pretty intimidated. This is the only video showing everything step by step. Nice work!
Thank you
I just bought an installer/remover tool for this exact issue with my 86.
Awesome. Good luck. Thanks for watching!
How does the shaft get installed
Sorry bad video I'm trying. Put one bushing in the control arm, Then send the shaft through the control arm side without a bushing the shaft must go in big washer side first install the big washer after you have sent it through the control arm. Now slide the small washer onto the shaft and install the bushing then add the sleeve and tighten the nuts add locktite. Thanks for watching! It was one of the first videos I shot some of my later stuff is better.
Hey how did you go about installing that 1 piece bushing on the upper control arm?
Sorry bad video I'm trying. Put one bushing in the control arm, Then send the shaft through the control arm side without a bushing the shaft must go in big washer side first install the big washer after you have sent it through the control arm. Now slide the small washer onto the shaft and install the bushing then add the sleeve and tighten the nuts add locktite. Thanks for watching! It was one of the first videos I shot some of my later stuff is better.