sorry i didn't fully understand your question but i guess you are asking about my hot air station settings if so i hope you find the following answer helpful for you It depends on your hot air station , and what you are doing As an example my hot air station is quick 861dw , if i will use it to remove the glue.i will set the temperature to 270 and the air at 60% , if i will use it to desolder a cpu i will start by 270 heat and 60% air then i will shift to 380 heat and 60% air and the last stage i will raise the temperature to 400 to remove the cpu without the risk of ripping pads It really depends on what works the best for you , you need to try and error till you reach the optimal settings that work the best for you
আপনার কাজ ভালো
👏👏
BROTHER SMD ? And heat and also alir
sorry i didn't fully understand your question but i guess you are asking about my hot air station settings if so i hope you find the following answer helpful for you
It depends on your hot air station , and what you are doing
As an example my hot air station is quick 861dw , if i will use it to remove the glue.i will set the temperature to 270 and the air at 60% , if i will use it to desolder a cpu i will start by 270 heat and 60% air then i will shift to 380 heat and 60% air and the last stage i will raise the temperature to 400 to remove the cpu without the risk of ripping pads
It really depends on what works the best for you , you need to try and error till you reach the optimal settings that work the best for you
what flux paste do you use
I'm using Amoe m50-10cc syringe flux , it does the required job , has to smell , isn't expensive and easy to clean .