He was good explain it and then guide step by step by showing the before and after an that is a great I can get it and then it is a good thing for me!!🤩
Thanks so much been trying to start my car for few weeks now thought it was ignition timing but watched this video and seen the leads problem and thought I Would try swapping mine stared right up first try thanks for the idea man great video
I change my brake pads of my honda civic 2018 i think the caliper wires touched each other and now the brake system light and the brake light are flashing when i put it in drive and the brake hold system won’t work do i need to change the caliper?
plugs were all wet hey? I just replaced wires on mine. Runs better but still, I think I have a bad injector. It diesels after I shut it off and it studders at low idle until I stomp on it.
Points condensers on the fords the voltage regulator was separate from the alternator the solenoid was separate from the starter you could put a manual chock on your carburator could have started or alternator rewound for 12 dollars be just like brand new radiator was metal and copper you could solder a hole and fix a leak same thing with power steering pump now there's no fixing something you have to replace it
I think this might be my problem.. 95 Nissan 200sx was running started misfire changed cap and rotor and plugs was fine week later started again was the maf changed thar ran for two weeks started again so i readjusted the rotor and cap was fine started missing again around 2.5 rpms. Then stopping at lights or signs the idle would sometimes drop below zero shut the car down but it will start up i got the car home hasn't started since took off fuel filter it seems to be no clog cause fuel was spitting then i took off the rotor cap just to have a look but thats new but this i have to try . Anything else i should try Hector? I have the exact twin cam motor
Bro I need help from Bangladesh, my car is Nissan Sunny X Saloon 2002 model, the car starts after some places then it stops suddenly, it starts again, after giving a lot of help, it cranks and does not start, after taking a rest for a while, it starts again. Turns on and off again, please tell me for which purse this happens.
Bro I may need your expertise. I just bought a nissan sentra 1997 the fan come on when the car gets to the correct temp. The fans stay on. I am in Marina Del Rey. I bought this car as my DD and some doordash on the weekend but this issue worries me
My old maxima did that. It was an aftermarket thermostat i put on not working correctly. It wouldnt open up and send the fans into overdrive. After putting an oem thermostat, never had any problems.
mine cranks and doesn't start. after 3 attempts it will start and then run fine. I leave it at idle for 30 minutes and the car runs fine. Once the car is warmed up to operating temperature i shut it off. When i go to restart the cart it will not start. I have check engine light on. its 1995 lexus sc400. i have fresh gas in the tank. it was sitting for 3 years so i drained the old gas and put new. I also put new battery. Plugs and wires are about 4 years old. what could it be?
You're a great mechanic and a better dad.
Living the life hector
No boss
No clocking in
Spending time with your son
Crank it, hold it, not you. Subscribed.
Gracias
Then small details!
Btw your a awesome dad. My kid fallows me around when I work on stuff
At the end of the video I couldnt help but notice the dip stick wasnt pushed in all the way, did you catch that? Great Video once again!!
hector doing the car gods work.
Old ignition stuff here when I started working on cars in the ,80 s alot of cars had points nowadays not many people know about points
Omar is going to make a great mechanic some day!
Sure is… just make sure he got his fries!!! 😂
Having no spark on my 1997 sentra right now, having a bit of oil leak so think this might be it. Thank you !!
Did u fix problem
I had the same problem 😳 with my Almera, and the problem was the fooled distribution pickup sensor with engine oil
He was good explain it and then guide step by step by showing the before and after an that is a great I can get it and then it is a good thing for me!!🤩
Thanks. I Have the same problem. I will test all that things.
When i'll find the mistake i will tell you. 😊
Thanks so much been trying to start my car for few weeks now thought it was ignition timing but watched this video and seen the leads problem and thought I Would try swapping mine stared right up first try thanks for the idea man great video
Suggestion;
Day in the life of HH start to finish
I had no idea that i could clean the inside of a distributor ! I have never seen that done. 😮
I change my brake pads of my honda civic 2018 i think the caliper wires touched each other and now the brake system light and the brake light are flashing when i put it in drive and the brake hold system won’t work do i need to change the caliper?
I would change the oil, because fuel could be mixed in from the excessive fuel in the cylinders.
Good job my friend!
plugs were all wet hey? I just replaced wires on mine. Runs better but still, I think I have a bad injector. It diesels after I shut it off and it studders at low idle until I stomp on it.
Have a problem with one b14 ga15 engine it just ticking and not tuning over 😕
Same with me ga16 97
great diagnosis at the end when it started,, logically why did it require so many hard cranks to actually get the motor running
Cylinder wash down
@@philh9238 sorry but what does that mean.
Basically means the engine was flooded from raw fuel cause there was no spark in the cylinders
Points condensers on the fords the voltage regulator was separate from the alternator the solenoid was separate from the starter you could put a manual chock on your carburator could have started or alternator rewound for 12 dollars be just like brand new radiator was metal and copper you could solder a hole and fix a leak same thing with power steering pump now there's no fixing something you have to replace it
I think this might be my problem.. 95 Nissan 200sx was running started misfire changed cap and rotor and plugs was fine week later started again was the maf changed thar ran for two weeks started again so i readjusted the rotor and cap was fine started missing again around 2.5 rpms. Then stopping at lights or signs the idle would sometimes drop below zero shut the car down but it will start up i got the car home hasn't started since took off fuel filter it seems to be no clog cause fuel was spitting then i took off the rotor cap just to have a look but thats new but this i have to try .
Anything else i should try Hector? I have the exact twin cam motor
let me ask where is the camshaft and crank shaft sensor located kindly and also mine keep stalling nissan sentra 1998
Where can I get the distributor for that model I've looked for it everywhere in South Africa with no luck
Great video my friend
LMAO "for the syncronization of the... Chingaleras right there"
At 4:28 u can hear the guy crying about the money 😂
i have done all of them still doesnt work. spark plugs works but engine doesnt work. does maf sensor cause start fault?
Good stuff!
Bro I need help from Bangladesh, my car is Nissan Sunny X Saloon 2002 model, the car starts after some places then it stops suddenly, it starts again, after giving a lot of help, it cranks and does not start, after taking a rest for a while, it starts again. Turns on and off again, please tell me for which purse this happens.
Bro I may need your expertise. I just bought a nissan sentra 1997 the fan come on when the car gets to the correct temp. The fans stay on. I am in Marina Del Rey. I bought this car as my DD and some doordash on the weekend but this issue worries me
My old maxima did that. It was an aftermarket thermostat i put on not working correctly. It wouldnt open up and send the fans into overdrive. After putting an oem thermostat, never had any problems.
What is up scannerdanner!
you left the engine oil deep stick up (yellow color) you can see clearly at 11:43
Whats Up Homie!!
mine cranks and doesn't start. after 3 attempts it will start and then run fine. I leave it at idle for 30 minutes and the car runs fine. Once the car is warmed up to operating temperature i shut it off. When i go to restart the cart it will not start. I have check engine light on. its 1995 lexus sc400. i have fresh gas in the tank. it was sitting for 3 years so i drained the old gas and put new. I also put new battery. Plugs and wires are about 4 years old. what could it be?
Hi my nissan sentra only swinging but not starting GA16 carb
A Nissan bluebird crank but won't start please identify the problem
Buenas tarde hecto tengo el mismo problem con un nissan 97 no en siende
I wash the engine can,t start check engine light is on.help me.
Always check the length of the post inside the coil. It will burn down over time. If it is a 97 CHANGE The Coil!!!!!!
OEM Nissan wires for those cars, or NGK.
Man, that car has a lot of chingaderas!
Its a no crank how to fix Its?
Grasias
More sound effects!
Fule pump?
Definitely 1913....still laughing out loud
If it was a 2013 you'd probably have to go to a junk yard to work on it.
Happy Easters
✌️✌️
Crankshaft position sensor
ok❤
HEECTOOR!¡!!
Bruh.... @9:50 😆
That sucks
Put some gas in it.
Sa America ka mag vlog lol
didnt help any, too many ads , wont seeing this, i wil rather destroy my car.
Nissan Sentra loss power
bad language gets no subscription from me