The sticker is on the cool plate side. It’s a lower heat that allows the part to stick and release. The tool is part of the default prints that come with the printer.
The GK2 is a wiled ride. I used only the corner papers at first to see what was off. Made some adjustments then used the paper to see if they were correct.
![ATEEZ(에이티즈) - [GOLDEN HOUR : Part.2] Preview](http://i.ytimg.com/vi/X4PfgRPBUVo/mqdefault.jpg)
Wow. You made that tool. Pretty nifty. What does the plate do, and why must it be protected?
The sticker is on the cool plate side. It’s a lower heat that allows the part to stick and release. The tool is part of the default prints that come with the printer.
The GK2 is a wiled ride. I used only the corner papers at first to see what was off. Made some adjustments then used the paper to see if they were correct.
What would we do without our spray bottles of alcohol? ;). The always handy solvent.
Wow, That is Deep, We would need to rub sand on it. Lol
How about you keeping the important parts of the action in the frame
Thank you for your comments.
is it ok to have those 2 air bubbles under it?
nm i see later you addressed them
Yea, Never good to have bubbles in the sticker.