i think i want the bed extetion too. i looked at your links and only seen amazon, if i buy it from the company it saves like 200$is are you an affiliate with them? @@philscraftcorner
i sure hope my pea brain and figure out how to make it run it is a little intimidating at how much thr is to learn. they recommend esel or somthing like that. might take me awhile but i sure hope i can learn it. its like a 1000 $ plus i need bits @@philscraftcorner
i followed your instructions the masuter pro turns on i have power i am getting no movement and a noise from i think the z motor when i press the home button thanks for the fantastic demmo
I tried to tighten the spindle but it is loose, as I was turning one of the screws the tool snapped off, I will have to order a replacement bracket. So word of warning be careful doing that.
Вы не получили максимум удовольствия от процесса сборки;) надо было не спеша, с пивком и клевой музыкой, а если еще и друзья будут советовать что и куда закрутить, то вы их даже сможете им показать куда идти с их советами. И получите максимум удовольствия😂 максимум
So show us a project with this machine! In another video an expert tell, that you should spend 3000 $ for a CNC, otherwise you will get frustrated. I don't know...
Realistic time to setup is very much appreciated
You are welcome
@@philscraftcorner how is your machine treating you?
Just ordered one with the 40w laser and Air Assist pump and can't wait for it to arrive. Great build video, cheers.
Nice. I hope you have a well ventilated place or a fume box to put it in.
Laser cutting produces a ton of smoke
You, lad, have two left hands
i sold an engine gantry, i believe next week ill be getting one of these. what you think
If you can afford the upgraded motor and are prepared to learn how to program it on the computer then it's definitely a good tool to have
i think i want the bed extetion too. i looked at your links and only seen amazon, if i buy it from the company it saves like 200$is are you an affiliate with them?
@@philscraftcorner
i sure hope my pea brain and figure out how to make it run it is a little intimidating at how much thr is to learn. they recommend esel or somthing like that. might take me awhile but i sure hope i can learn it. its like a 1000 $ plus i need bits @@philscraftcorner
i followed your instructions the masuter pro turns on i have power i am getting no movement and a noise from i think the z motor when i press the home button thanks for the fantastic demmo
By any chance have you accidentally pressed the e-stop button?
I tried to tighten the spindle but it is loose, as I was turning one of the screws the tool snapped off, I will have to order a replacement bracket. So word of warning be careful doing that.
Did you have the plastic sleeve around the spindle
@@philscraftcorner yes
Which program do you use to make the woods?
I used easel to design and save the grbl file. Then candle to send to the CNC machine
Вы не получили максимум удовольствия от процесса сборки;) надо было не спеша, с пивком и клевой музыкой, а если еще и друзья будут советовать что и куда закрутить, то вы их даже сможете им показать куда идти с их советами. И получите максимум удовольствия😂 максимум
So show us a project with this machine! In another video an expert tell, that you should spend 3000 $ for a CNC, otherwise you will get frustrated. I don't know...
А потом разочаруетесь, что потратили 3000 🤣😂🤣😂