My 013 v6 ram 1500 front driver windows is exactly have this problem since one rainy night at the beach driver unit control work passager side roll down but not roll roll up need to roll up whit the passager unit Driver window is holding ther whit red tape and roll down but not roll up 🆙 I figure out your video is giving me issue about what is going on in there 👍 I’ll try it my self or so i will have to pay the labor
If it's similar to a 2010 - door handle comes off from the top first. Pry top pivoting section with screwdriver outwards, then bottom pivoting section needs to be pried towards the front of the vehicle. It is easier to understand when looking at the new regulator panel assembly This is not a super difficult job. Just typical Chrysler makes it so that more steps are involved to accomplish the same thing
out of 10 how hard is this? i can do most maintenance on this truck but this one looks a little tricky. worth biting the bullet and saving some annoyance for $150 labor?
√ *Watch the Video*
√ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto
√ *Do it Yourself*
√ *Save Money*
I'm not sure if I missed it. But I didn't see you removing the door handle from the regulator panel. Thanks
Thank You for the Video it was great for my 2012 ST 1500. I had trouble removing the interior door handle on the old panel.
Great video. I just ordered a new regulator, hopefully I can fix it following these steps. Thanks again
My 013 v6 ram 1500 front driver windows is exactly have this problem since one rainy night at the beach driver unit control work passager side roll down but not roll roll up need to roll up whit the passager unit
Driver window is holding ther whit red tape and roll down but not roll up 🆙
I figure out your video is giving me issue about what is going on in there 👍 I’ll try it my self or so i will have to pay the labor
Excellent video.
You don't even sell the part...
If it's similar to a 2010 - door handle comes off from the top first. Pry top pivoting section with screwdriver outwards, then bottom pivoting section needs to be pried towards the front of the vehicle. It is easier to understand when looking at the new regulator panel assembly
This is not a super difficult job. Just typical Chrysler makes it so that more steps are involved to accomplish the same thing
What would I need to do to take the glass out and replace it?
I need the panned anyone know where I can find it??
I just needed too see the cable where it connects..mine kinda looks like a spin cast fishing reel i chucked in the lake
No door handle removal? Dodge over engineering
Of course you need a 10mm. Can’t find mine, dang it.
out of 10 how hard is this? i can do most maintenance on this truck but this one looks a little tricky. worth biting the bullet and saving some annoyance for $150 labor?