Thanks a million times dear Engineer, that was very helpful, yet i still have two short questions please; * May i get the model number of the valve / data sheet i want to study this valve for more knowledge, * may i know what the terminal numbers 9/10 are for ? * Why in the signal measuring process @07:41 you did not break the loop from the signal wire which is connected to terminal number 7 then please which terminal/signal wire did you connect the Fluke 745 ? I do highly appreciate your valuable reply and spreading your knowledge to the world
@@kevin00861 just give me a time to answering your query bro ,I will ask to my E and I Engineer regarding your question...I'm sorry too because I didn't translate in English ..thanks for watching...
@@kadisyertochannel Thanks a million times brother, May i get your email or any contact so i send you my query so you could access it easily later, as your RUclips channel has lots of likes and it would be hard to find my question later
Great For the terminal IP to convertor you should check input + and - and connect the fluke 2 lead and for output check the controller output and connect the +and - as per polarity. The model is mil control valve and controller is Siemens IP to convertor.@Malik Arthur
Thanks a million times dear Engineer, that was very helpful, yet i still have two short questions please;
* May i get the model number of the valve / data sheet i want to study this valve for more knowledge,
* may i know what the terminal numbers 9/10 are for ?
* Why in the signal measuring process @07:41 you did not break the loop from the signal wire which is connected to terminal number 7 then please which terminal/signal wire did you connect the Fluke 745 ?
I do highly appreciate your valuable reply and spreading your knowledge to the world
Thanks for liking my comment,
Is there any answer to my technical concern, please
I highly appreciate that Sir 🙏
@@kevin00861 just give me a time to answering your query bro ,I will ask to my E and I Engineer regarding your question...I'm sorry too because I didn't translate in English ..thanks for watching...
@@kadisyertochannel
Thanks a million times brother, May i get your email or any contact so i send you my query so you could access it easily later, as your RUclips channel has lots of likes and it would be hard to find my question later
Great
For the terminal IP to convertor you should check input + and - and connect the fluke 2 lead and for output check the controller output and connect the +and - as per polarity.
The model is mil control valve and controller is Siemens IP to convertor.@Malik Arthur
@@kadisyertochannel
Thanks a million times,
i highly do appreciate your feedback,
please keep posting more videos,
thanks again bro
Full support ka Disyerto
harang tol sending support mwab ..