Tanks man it was rally help full i have order one metal kit eheheh and have some questions like the Inês you talk and you are rigth the instrutions are complicated tanks for the vídeo keep doing does 👍👍👍 hug from Portugal 💪💪
You can trim or cut the driveshaft a little so you can get full telescoping of the driveshafts. I am not sure why some bind and some dont. But that's what I would do. Trim the female end first of the driveshaft then make end if needed. Cut a little at a time till it all moves freely. Hope that helps!
@@RunThatRC Hi David, have you trimmed your driveshafts yet? What tool do you use? I'm thinking about using my Dremel but I don't want to bend the female end and have it not telescope smoothly anymore. It looks like both driveshafts connected to the center axle are too long, even when fully retracted.
![[WPL 6x6] Ultimate Axle Set Up Guild Silk Smooth Gears! (B16 KM) Will also help with 4x4 C24](http://i.ytimg.com/vi/ZyhOQvwGr04/mqdefault.jpg)
I like the use of pliers to reduce the shaft size. Top idea!
Tanks man it was rally help full i have order one metal kit eheheh and have some questions like the Inês you talk and you are rigth the instrutions are complicated tanks for the vídeo keep doing does 👍👍👍 hug from Portugal 💪💪
Glad I could help
Thanks bud that did help out 👍
Appreciate what you do 🤜🤛 thank you for sharing bro🤟😉
thanks for stopping by! Glad it helped.
Great little trick👍👍
Thanks! It's the improper tool use trick lol😎
You should change it into a metal transmission gearbox to achieve more torque.
I think im going to do the 2 speed. It's been reliable for me. Even with a brushless motor!
Hi, I feel that the rear driveshaft is very tight. doesn't allow free suspension movement?. any idea?
You can trim or cut the driveshaft a little so you can get full telescoping of the driveshafts. I am not sure why some bind and some dont. But that's what I would do. Trim the female end first of the driveshaft then make end if needed. Cut a little at a time till it all moves freely. Hope that helps!
@@RunThatRC Hi David, have you trimmed your driveshafts yet? What tool do you use? I'm thinking about using my Dremel but I don't want to bend the female end and have it not telescope smoothly anymore. It looks like both driveshafts connected to the center axle are too long, even when fully retracted.
Nice dude some good info
Hello David, what are the screwdrivers do you use for building B36 Kit. And do some of them come with the kit?
im just using cheap Phillips head screwdriver and usually the kits come with allen head wrench for the grub screws.
@@RunThatRC Great thanks for reply! 🙋
Why would you not use a file to remove the knurling?
I dont have one lol
Hey. How do you Assemble the middle axle. I can’t figure it out. Maybe I’m missing some gears. Thanks 🙏
go check out the Official WPL website. They have updated instructions that should guide you through it.
www.wpl-rc.com/?ref=DAVIDCLARK
Super 👍
You should buy spring for chainsaw starter it has 5mm and make from it leaf springs you just need to hit it up to dril and to flex
Sir, thank you for your instruction. I would appreciate any further video upgrades to this mode/manufacturer. . Full metal jacket.