Hi, my defender always levels itself so the front is -1degree (on a flat surface). Dealer checked everything, no errors analysed, no hardware issues either. What would you recommend? I compared it on the same surface with another defender with air suspension and the lowered front is immediately visible. Thanks for any advice
Great video learnt a lot. My range rover sport drops over night. Mostly the 2 front shock goes down completely. Back shocks are okay. Dont know what to do
Get a water bottle with some soapy water and spray the inlets to the front air-line to your front airbags. See if there is any leaking at the inlet where the tube is inserted. Could be a bad o-ring and leaking air. If not there, then most likely culprit is the front valve block leaking back to the pump. You have a couple options if this is the case, replace the front valve block or you can try and replace the o-rings on the OEM. Search the internet for both options How-to. I haven't tried the aftermarket valve blocks but I have seen some for less than $50 with mixed reviews. OEM is pricey, but there are some aftermarket that are in the $150 with very good reviews.
Do you know the correct height for the new Defender's (center of the hub to wheel well)? I have a 2022 and would like to double check the height. Thanks!
My l320 keeps telling me to clear obstacle So stays in extended mode. Changed compressor and all 3 valve blocks. All corners are reading roughly the right hight Any ideas please I'm sick of throwing money at it.
I have a 2006 rrs supercharged... My car was fine and out of boredom i selected calibrate anti roll option then i got e 7 error code and my red suspension light is on... Everything still works ie suspension goes up an down etc but now the red light stays on and fault code C 1 A00-54 - Control module - System programming failure - missing calibration (AB)... 😮... Any advice please 🙏
@@rogerhalstead2595 yes I got hold of the lads at gap and they were a great help they kept sending me an update on my device again and again and again till finally it worked
The best suspension class I’ve ever seen.
Hi, my defender always levels itself so the front is -1degree (on a flat surface). Dealer checked everything, no errors analysed, no hardware issues either. What would you recommend? I compared it on the same surface with another defender with air suspension and the lowered front is immediately visible. Thanks for any advice
Thank you Duncan Well Done!
Grande Luiz! Exatamente a falha que minha viatura está apresentando (sensor traseiro direito)
Logo ela estará com você para me salvar!😂
Great video learnt a lot. My range rover sport drops over night. Mostly the 2 front shock goes down completely. Back shocks are okay. Dont know what to do
Get a water bottle with some soapy water and spray the inlets to the front air-line to your front airbags. See if there is any leaking at the inlet where the tube is inserted. Could be a bad o-ring and leaking air. If not there, then most likely culprit is the front valve block leaking back to the pump. You have a couple options if this is the case, replace the front valve block or you can try and replace the o-rings on the OEM. Search the internet for both options How-to. I haven't tried the aftermarket valve blocks but I have seen some for less than $50 with mixed reviews. OEM is pricey, but there are some aftermarket that are in the $150 with very good reviews.
I got a brand new Defender and the ride is firm. Could it be in tight tolerance mode? Do they come from the factory like that for transport?
Do you know the correct height for the new Defender's (center of the hub to wheel well)? I have a 2022 and would like to double check the height. Thanks!
Hi Paul, Sorry we cannot find these values on Land Rovers technical information site! Only road to roof height
Thank you
Nice work
My l320 keeps telling me to clear obstacle So stays in extended mode. Changed compressor and all 3 valve blocks. All corners are reading roughly the right hight
Any ideas please I'm sick of throwing money at it.
Thanks 👍🏻
I have a 2006 rrs supercharged... My car was fine and out of boredom i selected calibrate anti roll option then i got e 7 error code and my red suspension light is on... Everything still works ie suspension goes up an down etc but now the red light stays on and fault code C 1 A00-54 - Control module - System programming failure - missing calibration (AB)... 😮... Any advice please 🙏
HI 👋. I have the same issue, did you fix yours?
@@rogerhalstead2595 yes.... I contacted gap and they were great... They made me uodate my tool 2 to 3 times till it cleared
@@rogerhalstead2595 yes I got hold of the lads at gap and they were a great help they kept sending me an update on my device again and again and again till finally it worked
Great vidio
Very informative video but voice to low boss don't mind and thanks allot
👍🇺🇦
Lol