Hayden, have you had experience with CAT935 with backhoes? I've seen one out there and was wondering about your thoughts on one of them. Some folks think that they are desperate machines and that one is better off avoiding it and that a 935 without backhoe would be better & that if you have trenching work to do get a CAT 311 or CAT312 to do that work and just hold on to a CAT 935 with a 4-in-1 bucket to move earth / level construction site..
Hi mate! Im in need of taking that plate off, and resealing it, gasket has given up! How do you get it off? Oil pan is off, just trying figure out the plate
i believe there is 4 bolts,1 in each corner its been almost 2 years since i built mine, but i do remember bolts just not sure on the number. i assume you are talking about the intermediate oil pan plate?
Pin the flywheel, pin the pump, make sure number 1 rocker arms are rocking this indicates top dead center on number 1. Torque the pump gear while pins are installed, remove pins and reassemble. Prime fuel system with the priming pump, loosen the injector lines at the injectors and move the governor rod to the run position and fuel will come out at the injectors, tighten it all up and it will start if pump is rebuilt correctly
Tankyuo
Hayden, have you had experience with CAT935 with backhoes? I've seen one out there and was wondering about your thoughts on one of them.
Some folks think that they are desperate machines and that one is better off avoiding it and that a 935 without backhoe would be better & that if you have trenching work to do get a CAT 311 or CAT312 to do that work and just hold on to a CAT 935 with a 4-in-1 bucket to move earth / level construction site..
Hi mate! Im in need of taking that plate off, and resealing it, gasket has given up! How do you get it off? Oil pan is off, just trying figure out the plate
i believe there is 4 bolts,1 in each corner its been almost 2 years since i built mine, but i do remember bolts just not sure on the number. i assume you are talking about the intermediate oil pan plate?
Good day am working on a 3304 engine I change fuel pump but engine not starting. Could you help me with some of your knowledge.
Pin the flywheel, pin the pump, make sure number 1 rocker arms are rocking this indicates top dead center on number 1. Torque the pump gear while pins are installed, remove pins and reassemble. Prime fuel system with the priming pump, loosen the injector lines at the injectors and move the governor rod to the run position and fuel will come out at the injectors, tighten it all up and it will start if pump is rebuilt correctly
How to time the fuel pump
Pin flywheel and make sure number 1 rockers are loose, pin pump, torque bolt/nut on pump remove timing pins.
@@HaydenIngram could you do a video on it thank you
@@paulfarquharson6575 should have one on here