that is controlled by the microcontroller. when the voltage by voltage divider fall below the limit. (resistors on the board and float level sensor inside the fuel tank) afetr a specified time gap, the microcontroller will drive the pointer to low level and then it will trurn on the LOW FUEL WARNING LED
hello Sir i have bad diode f1k, i want to replace, what should i look in datasheet for replacement, can i use us1m diode. is it going to work. thank you Sir
I have a humble request to you. Can you make a lesson for me to use P channel mosfet as a switch controlled by arduino. Please please please, thanks in advance.
So from the factory, the dials are only just sitting on pcb pads, not soldered down? Wow that's an incredibly poor and lazy design...... designed to fail ;-)
Masha-Allah. Wish I could got a instructor like you. All time I got charmed after watching your videos. May Allah give you holy life.
I like this testing as i do auto electrics . its allways good to see how circuits work.
Every video is better than the other.🤝👌
"What role does the fuel sensor ground play? Would it create problems if it connects to a common ground?
How can I understand if there is a problem with this gnd?
Excellent thanks for sharing this informative video❤❤
Vare naise sar sar vfd explayn kar Dan thanks ❤❤❤
❤ Thanks 😊
Good 👍
Sir please explain how fuel led turn on and off
that is controlled by the microcontroller. when the voltage by voltage divider fall below the limit. (resistors on the board and float level sensor inside the fuel tank)
afetr a specified time gap, the microcontroller will drive the pointer to low level and then it will trurn on the LOW FUEL WARNING LED
@HaseebElectronics thanks
How to change the odometer to lower mileage 72,500. ? That would be interesting.
@@mrBDeye that is doable but it is not fair.
It is also prohibited by law from the manufacturer side.
hello Sir i have bad diode f1k, i want to replace, what should i look in datasheet for replacement, can i use us1m diode. is it going to work. thank you Sir
Amplifier board aur SMPS efficiency kaise nikaalenge please ek video reply 🙏🙏🙏🙏🙏
I need some cable tv set top box repairing coshp. CHANGONG circuit and voltage details ❤
I have a humble request to you. Can you make a lesson for me to use P channel mosfet as a switch controlled by arduino. Please please please, thanks in advance.
10.
So from the factory, the dials are only just sitting on pcb pads, not soldered down? Wow that's an incredibly poor and lazy design...... designed to fail ;-)
Yes in most of all clusters
The stepper motors are not soldered . Just locked