How to Replace ABS Wheel Speed Sensor 06-12 Toyota RAV4
HTML-код
- Опубликовано: 21 окт 2024
- Buy Now!
New ABS Wheel Speed Sensor from 1AAuto.com 1aau.to/ia/1ABE...
1A Auto shows you how to remove, install, change or replace a rusted or defective ABS wheel speed sensor. This video is applicable to the 06, 07, 08, 09, 10, 11, 12, Toyota Rav4.
🔧 List of tools used:
• Phillips Head Screwdriver 1aau.to/o8F/1AX...
• 10mm Socket 1aau.to/oPp/1AX...
• 21mm Socket 1aau.to/opf/1AX...
• Pliers
• Ratchet 1aau.to/o99/1AX...
• Socket Extensions 1aau.to/oVG/1AX...
• Torque Wrench 1aau.to/osV/1AX...
• Rust Penetrant
• Center Punch 1aau.to/ob6/1AX...
• Hammer 1aau.to/ojz/1AX...
• Wire Brush 1aau.to/odQ/1AX...
For More Info visit us at 1aau.to/h/bTp/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ *Watch the Video*
√ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto
√ *Do it Yourself*
√ *Save Money*
I literally just got done changing this today thanks to your video. I do have to say tho, I didn't notice the part didn't come with any nuts so I had to make a run to the parts store. A little bit of a inconvenience but still got it done.
any video on how to change the front ones?
May want to specify somewhere that this is applicable only to the 4WD models. The 2WD models unfortunately have a different design that requires significantly more disassembly.
Thanks for the very handy and informative video. It also works for the related Toyota vanguard
6:38 really curious to know if the debris falling inside wont affect the performance of the sensor? honest question here gotta do this job soon.
Is this sensor the same as the yaw rate sensor?
Can't find a replacement for the cord on my 2005 highlander. both ends of the cord look like interior connector in this vehicle. Right Rear connector FWD.
I have 2005 lihgts are on won't re sets do you think that could be the sensor s
I recently bought a 2006 Rav4 4wd 4 cylinder, while cruising on the highway suddenly the ABS lights turned on along with the check engine, VSC, ABS and airbag warning lights.
The obd scanner showed 5 errors regarding the ABS. The errors are C0200 , C1201 , C1223 , U0123 , U0124 , U0126
I tried changing the ABS module, but the same codes kept on showing!
Are the wheel speed sensors bad in my case ? And is cleaning/changing them going to solve my issue ?
How to off abs light for toyyota rav 4 2006 model
I ripped my wires out when using a slide hammer to get the hub off. A $65 mistake. Make sure you take it easy with a slide hammer. They work a little too well.
+A brother in Christ Thanks for the tip!
Can anyone answer this, can this cause the slip indicator, vsc, abs and brake light being on? The lights always turn off when I change my rotors but comes back on slightly after. Is that caused by these sensors? Thanks
I cleaned my maf sensor and airfilter and put a cataclean fuel cleaner in and mine went off, a few weeks later it returned, im being told its possible o2 sensor, the vsc/abs lights can show up when the system detects a fault even if its with an o2 sensor, the toyota will dissable the vsc system, meaning you cant use cruise controll, abs or 4x4.
If this doesn't solve your issue then do a full brake system bleed, if still nothing, then its master cylinder and if still your having issues its the dreaded super expensive ABS module 😢
I have 2009 rav4. Driver side rear weel make noise(loud noise) while driving.. I off the engine and restart and drive noise goes away. Can anyone know the problem please . It is 4wd
+rajiny navaratnasingam We wouldn't be able to diagnose an issue like that here, you may want to have a local mechanic take a look at it. Thanks for checking us out! 1aau.to/m/Shop-1AAuto-c
How did you know which sensor was spoilt?
My goodness I thought it was DIY.
+Helevatic Thanks for watching! Like diagnosing most electrical issues on modern vehicles, you will need to utilize an OBD-II code reader to zero in on which sensor needs replacing.
I've got a 2010. Tried 3 different ODBII readers and all said the car was perfectly fine. And yet the dashboard was lit up like Christmas tree. Took to a dealer, they charged $135 for diagnostic and told me I needed to replace this sensor on driver side. They wanted another $650 for the job which is where I told them tk have a nice day and came here. I've replaced these sensors on several previous cars and still somewhat surprised that the reader didn't pick up the code on this one 😕
Dont mention to the diy'er how the broken bolts need to be removed Leave em in the dark, bc it dont sell as many parts that way
🤔👍