Camera automation: motion turns on a light

Grid Connect is a home automation app that works with a range of electronic devices. It empowers users to setup their own cost-effective home automation network without the need for installing multiple apps on their mobile device, allowing users to select from a wider range of smart electronic products.

[@glenb.9811]

For my Orion pan/tilt camera, I added a command to disable motion detect before turning the light on, then 30 second delay after turning the light off, then enabling motion detection. Reason-the light switching off would cause the motion tracking to move the camera. When it reset its position, the camera would detect this as motion and trigger the automation. Thirty second delay after turning the light off allows the camera to stabilise its position before motion detection activates, so only objects in motion trigger the automation.

[@TheGCbear]

I continue to follow this step by step and it doesn’t work. I went out and purchased the newest motion sensor with the newest hub and a brand new lightbulb. All arlec all connected to the hub but it never works

[@Angie_bmwgirl]

I put a pin in to reset my camera because there was a problem with my home and at work and I possibly pressed harder than I was supposed to and now I cannot reset the camera again it’s not doing it because there’s nothing there I pushed it hard with the pin is there another way that I can reset this beautiful camera because I feel like breaking it now

[@alexanderloua7964]

WHERE IS THE FRIKEN PARING BUTTON