Should the lap bars return to the neutral position freely? I have a MZ Magnum 54in deck w/ K740 engine.When pulling bars to the rear position, the bars return to neutral, however when pushing bars full forward the bars do not return completely. Is this normal? Thanks
Can someone please advise how to adjust the valves so I can move (not running 2015 Outlaw XP)? There are two vavles on hydraulic pumps but not sure which direction to move them. Thank you!
I would personally have drive wheels off ground minimally to avoid the load weight of machine for first few half dozen back and forth "purging" then once confirmed seem bled THEN put on ground to reconfirm proper noise and engagement . 👍
Only problem Is the filter cover is cheap but plastic crap and strips…. And hang up up getting a box end wrench on it with the linkage and framing around to get a good bite. I am highly upset they used suck a cheap PoS cover and stupid design on a 8k mower
This video saved my bacon. Couldn’t find the fill plugs and the half turn screws on the top I thought might be the fill plugs. Thanks!!!
Gotta love You Tube and those that create and post videos to help us so much. Thank you. Andy K
thanks guys it was super easy with your help !! I hope to see more videos about the badboy outlaw👍👍👍
Should the lap bars return to the neutral position freely? I have a MZ Magnum 54in deck w/ K740 engine.When pulling bars to the rear position, the bars return to neutral, however when pushing bars full forward the bars do not return completely. Is this normal? Thanks
On the ZT-4400, does it matter which direction you turn the purge valves 180 degrees?
Can someone please advise how to adjust the valves so I can move (not running 2015 Outlaw XP)? There are two vavles on hydraulic pumps but not sure which direction to move them. Thank you!
I would personally have drive wheels off ground minimally to avoid the load weight of machine for first few half dozen back and forth "purging" then once confirmed seem bled THEN put on ground to reconfirm proper noise and engagement . 👍
Oil fill vent plug is damn near impossible to access.
Mine has an Allen screw head and not a hex head. Screaming to be stripped out.
Only problem Is the filter cover is cheap but plastic crap and strips…. And hang up up getting a box end wrench on it with the linkage and framing around to get a good bite. I am highly upset they used suck a cheap PoS cover and stupid design on a 8k mower
Why the fuck wont uour video keep playing