HEY I DID IT SAME BUT STIMULATION IS TAKING TOO MUCH TIME AND NOT GENERATING SHOWING THIS ERROR Solution failure in the First Step may be due to: 1. Lack of adequate fixtures for one or more parts 2. Material properties may not be properly defined. 3. Load Increment may be too large or too small. (too small displacements -> convergence failure)
It sounds like you have some fixture no applied correctly or not applied at all. On top of this, the stresses in the video are unrealistic, but probably occur because a linear elastic material model was used in the nonlinear simulation. In order to simulate yielding in SW simulation, either the stress/strain curve or the tangent modulus has to be defined and a plasticity model choosen in material properties.
im getting error showing a solution failure : 1 1. Lack of adequate fixtures for one or more parts 2. Material properties may not be properly defined. 3. Load Increment may be too large or too small. (too small displacements -> convergence failure) what should i do?
How long should a single simulation last ?
HEY I DID IT SAME BUT STIMULATION IS TAKING TOO MUCH TIME AND NOT GENERATING SHOWING THIS ERROR
Solution failure in the First Step may be due to:
1. Lack of adequate fixtures for one or more parts
2. Material properties may not be properly defined.
3. Load Increment may be too large or too small.
(too small displacements -> convergence failure)
It sounds like you have some fixture no applied correctly or not applied at all. On top of this, the stresses in the video are unrealistic, but probably occur because a linear elastic material model was used in the nonlinear simulation. In order to simulate yielding in SW simulation, either the stress/strain curve or the tangent modulus has to be defined and a plasticity model choosen in material properties.
Please make a full video tutorial on this pipe bending simulation.
im getting error showing a solution failure : 1
1. Lack of adequate fixtures for one or more parts
2. Material properties may not be properly defined.
3. Load Increment may be too large or too small.
(too small displacements -> convergence failure)
what should i do?
How can i apply the rolling fixture for a tow cart , i want to use this method to pull my cart
Hi Anthony, did you found a solution ?
Hi sir 👋
Please i have a problem in bending tube can you help me? 🥰
Thanks 😊
Can you share the file with simulation study ?
How to understand Non-linear simulation?