Dovetailed Tea Box

I presented this box to my girlfriend in 2021.
Full build of the dovetailed tea box originally done By Mike Pekovich from Fine Woodworking issue No.269. I encourage you to check out the plans for this project or at least the issue that featured this project for detailed measurements.
I used the same materials and dimensions from the article, wenge exterior, with curly/bird's eye maple for the inner liner.
The wire brush was used on the wenge box parts to give enhanced texture by basically brushing away the soft grain lines.
The only clip I missed recording was gluing in the wedge dowel in the elongated slot in the base where the two cords passed through to secure them tightly (14:30).
Router bit used to clear out dovetail waste: Whiteside #3000 Template Bit with Ball Bearing (1/4" Shank, 1/2" Cutting Diameter, 1/4" Cutting Length).
Rare earth magnets for the clasp from Lee Valley.
Clasp cord was natural twisted jute rope cord, 4mm from Amazon.
Clasp cord wrap was natural 2-ply jute twine, 1mm from Amazon.
Music by Terry Saige - The Hunt - thmatc.co/?l=492E3C3B
Music by CFEQ - Untitled 24 - thmatc.co/?l=BFDB3A3D

[@jaayjones5937]

Subscribed because you were kind enough and intelligent enough to tell what router bit you used.

[@TheGrantAlexander]

Beautiful box Bob!

[@ruudhooff6486]

Enjoyed the video a lot, thanks. You have some mighty fine tools, wonder if I just watched the best equipped workshop on RUclips.