My 1.6i Corsa B was has been idling extremely poor. I just bought a new idle control valve, but after installing it, the revs literally go up to 3000 and stay there. Do you know how to solve this problem? I haven't allowed the car to run like this for more than a few seconds. Do I need to let it idle for a while?
@@tristanvanderwalt6321 You could try that, no harm in letting your engine run 3000rpm for a little bit, however you should check for air leaks or you can use an OBD2 scanner, with the port being located on a little panel under the headlight switch. You should buy an OPcom or VAUXcom obd2 scanner and use a laptop, then you could check car info and see what's wrong. Don't bring it to a mechanic unless you absolutely have to, most of them just put on random parts and charge you for it while they get money by doing basically nothing.
hi mycorsa struggles with starting up after leaving it for an hour or 2 and whn it finally starts it shakes and low rev counts thers also a sound coming from the throttle hissing sound any help
Guys I have a opel corsa utility bakkie 2006 When am on gear 2, full clutch In it takes the Rev count to 2000Rpm When I balance the clutch (without gas suppoort) while it's still on gear 2 it goes back back go 1000rpm Do u think its the same thing?
Hey guys my Opel Corsa lite switches off whenever I come to a stop, it happens now and then. It idles fine. When I come to a stop the revs will drop to the point the oil light goes on and then goes up to a 1000rpms, sometimes the revs drop and then car switches off when coming to a stop. Any suggestions?
@@lehlohonolofaku3178 thanks bro, it was actually the idle control valve. I replaced it but then the car was idling at 3000rpm, and there's no way of manually setting the RPMs so had to take it so they can do it electronically
Hi good day my opel corsa lite 1.6 idle somethings okey aftr i drive it drives right than it cut off than the enjin light fliker after that i start it nd drive
Im in JHB. my corsa wont allow me to pass 3000rpm. it misfires and check engine light comes on and I have replaced that sensor and bought it at goldwagen.. Idk now.. what might be the problem anyone?,
is it running rich if so its the o2 sensor on the exhaust manifold it could be faulty coils /coil pack , change youre spark plugs as well back fire is a result of pre detonation or over fueling / , if its over fueling you would have suffered from bad gas mileage previously or the smell of gas petrol from the exhaust when idling , hope this is help-full
Thanks, v interesting! But could you/someone please confirm that this will not prevent a car from running. My Corsa C fires up but cuts out. Cleaned/ changed all the usual suspects but would like to rule this out before removing the ecu and getting it tested.Thank you.
Can be your key transporter. Or your crank position sensor or could be a damage keyway on your crank gear. And one more ...if your have a aftermarket alarm,that will also cause a problem
@@ASHTONSVEHICLEMODSAVM Thank you. Autoelectrician checked the key, it's okay. Sensor changed. Only keyway not checked; in fact only know about those on mowers, etc. I gave up and garage picked it up. Mechanic can't find anything..except he found oil in ecu plug which Ive read can come from the oil pressure switch wire. He's sent the ecu off for testing. Oh, he also checked the catalytic converter is not blocked. Thanks again.
Mine opel high idles all the time. I bought a new one for 100bucks but unfortunately it still doing the same thing. I'd be standing at a stop street/traffic light and boom the idle with shoot up. Any car part shop should sale it.
This video has only one flaw, a part that is obviously threaded was forced out!? I think it should be, first to release the spring pressure on the element and then unscrew the element. Disclaimer, I'm not a mechanic!
Авто/Мото
Thanks bro your video helped out I almost bought a new one
Thanks brother....been struggling with my Opel Cadett same problem...hope this will save me. Am in Cape Town
Great tip, thanks...
Thank you for sharing ❤
This was helpful
Sweet leka my man ima try it
Nice tips
Does your car temperature goes up 90° C, and the fan switch on often ?
I have the same problem . i'm going to try it and ill get back with my answer!!!
My bakkie does not want 2 idle😭, I'll try this and see...appreciate the knowledge broski
Had same problem, check pickup /idle sensor give it a clean or replace, check timing and coil
I get rough idle after battery replaced.Any idea why? Meriva B,1.7cdti
My corsa was idling rough, but now it just sits at 3000rpm, thanks 😊 👍
My 1.6i Corsa B was has been idling extremely poor. I just bought a new idle control valve, but after installing it, the revs literally go up to 3000 and stay there. Do you know how to solve this problem? I haven't allowed the car to run like this for more than a few seconds. Do I need to let it idle for a while?
@@tristanvanderwalt6321 You could try that, no harm in letting your engine run 3000rpm for a little bit, however you should check for air leaks or you can use an OBD2 scanner, with the port being located on a little panel under the headlight switch. You should buy an OPcom or VAUXcom obd2 scanner and use a laptop, then you could check car info and see what's wrong. Don't bring it to a mechanic unless you absolutely have to, most of them just put on random parts and charge you for it while they get money by doing basically nothing.
Did you solve the problem
hi mycorsa struggles with starting up after leaving it for an hour or 2 and whn it finally starts it shakes and low rev counts thers also a sound coming from the throttle hissing sound any help
If your car does not drive the way it's supposed to drive what can be the problem pls.
Hey man whats that pink jelly thing
We're dose this air valve set on the motor
Corsa utility Bakkie won't start, what could be the issue?
My corsa when its warm drops rpm when i press clutch
This is happening to my corsa and it's so frustrating. It just cuts out on me while I'm drying. and the Revs just drop below 1000 and it cuts out.
not idle sensor on yours ,its the throttle sensor
@@lehlohonolofaku3178 correct
Hi can you tell me what is the red staf that you use pls
Just buy grease it any grease
My Corsa B refs up and I changed I bought the new sensor still. I don't known what to do anymore . I'm based in Joburg
You bought a Wrong Sensor just check all Sensors
Guys I have a opel corsa utility bakkie 2006
When am on gear 2, full clutch In it takes the Rev count to 2000Rpm
When I balance the clutch (without gas suppoort) while it's still on gear 2 it goes back back go 1000rpm
Do u think its the same thing?
Same here did you find the problem
It's not working pulling out the screw with pliers!
Hey guys my Opel Corsa lite switches off whenever I come to a stop, it happens now and then. It idles fine. When I come to a stop the revs will drop to the point the oil light goes on and then goes up to a 1000rpms, sometimes the revs drop and then car switches off when coming to a stop. Any suggestions?
Good day. I have exactly the same problem with my Corsa 2006 1.4 utility. How did u resolve the problem?
??
throttle sensor
@@lehlohonolofaku3178 thanks bro, it was actually the idle control valve. I replaced it but then the car was idling at 3000rpm, and there's no way of manually setting the RPMs so had to take it so they can do it electronically
Hi good day my opel corsa lite 1.6 idle somethings okey aftr i drive it drives right than it cut off than the enjin light fliker after that i start it nd drive
Can be a faulty temperature sensor on the head
Were are you based@@ASHTONSVEHICLEMODSAVM
Im in JHB. my corsa wont allow me to pass 3000rpm. it misfires and check engine light comes on and I have replaced that sensor and bought it at goldwagen.. Idk now.. what might be the problem anyone?,
is it running rich if so its the o2 sensor on the exhaust manifold it could be faulty coils /coil pack , change youre spark plugs as well back fire is a result of pre detonation or over fueling / , if its over fueling you would have suffered from bad gas mileage previously or the smell of gas petrol from the exhaust when idling , hope this is help-full
Thanks, v interesting! But could you/someone please confirm that this will not prevent a car from running. My Corsa C fires up but cuts out. Cleaned/ changed all the usual suspects but would like to rule this out before removing the ecu and getting it tested.Thank you.
Please check your TPS and your crack gear ,the keyway gets damaged, and timing goes out
And if you want to change any sensors in an aftermarket brand. Please use euroman.good as oem
@@ASHTONSVEHICLEMODSAVM where are you?
Can be your key transporter. Or your crank position sensor or could be a damage keyway on your crank gear. And one more ...if your have a aftermarket alarm,that will also cause a problem
@@ASHTONSVEHICLEMODSAVM Thank you. Autoelectrician checked the key, it's okay. Sensor changed. Only keyway not checked; in fact only know about those on mowers, etc. I gave up and garage picked it up. Mechanic can't find anything..except he found oil in ecu plug which Ive read can come from the oil pressure switch wire. He's sent the ecu off for testing. Oh, he also checked the catalytic converter is not blocked. Thanks again.
What will make ur vehicle loose power
Timing
That thing wil not out bay me
Hi there. Can i use WD-40 to clean the idle sensor?
Hi, you can but will not be very effective, just buy carb spray, its like R40.
Thanks
Ok thanks mate!
@@ASHTONSVEHICLEMODSAVM is this a permanent solution?..my car has a brand new sensor and it started giving issues after a week
@@jaredmmc if it's a brand new sensor, then will not be your issue ,can be your tps or temperature sensor
@@ASHTONSVEHICLEMODSAVM which one is temperature sensor..?
Can't push it in😢
Same thing with Opel Astra G 1.4
Opel gamma
Thank you i had to buy a new than just to clean it
You bought it how much and where?
Mine opel high idles all the time. I bought a new one for 100bucks but unfortunately it still doing the same thing. I'd be standing at a stop street/traffic light and boom the idle with shoot up. Any car part shop should sale it.
This video has only one flaw, a part that is obviously threaded was forced out!? I think it should be, first to release the spring pressure on the element and then unscrew the element. Disclaimer, I'm not a mechanic!
How do I get hold of you????
DONT DO THIS!! the unit will fall apart later, Replace it if its troublesome, lots of stupid people on youtube now-adays!!!