That remote starter is for manual transmission too were, u select the second ignition starter & acc the small green cable if u cut it will be for manual u need to connect ebrake when u shot car off will keep running until close last door like that cant be left on gear, also if u program the tach an connect cable it will cranck as much it needs to start
Hey Bro just startes installing this same device... But wanted to ask you if the small gauge wires that say "trigger starter input" are supposed to be connected.... because my device is not starting the car...and what wire do they go to on the car.... Thank you so much..
So on the 12 pin small Grey connector, you only used the brake and hood input wires and nothing else? If I wire the 8 pin power harness and the brake, hood, and lock + unlock outputs for my power locks and just wrap up everything else from the 12 pin will the remote start and keyless work? Thank you for the video, it was very helpful
For incorporating the power locks. Can you pair the new key fob to the existing power lock system? So the lock or unlock rf signal goes straight to the after market module and not through the remote start module
If not you can use a rf cloner. They come with 4 buttons that will clone most rf signals. You could clone the remote start and lock fobs on to one. You’d just lose the two way feedback
That remote starter is for manual transmission too were, u select the second ignition starter & acc the small green cable if u cut it will be for manual u need to connect ebrake when u shot car off will keep running until close last door like that cant be left on gear, also if u program the tach an connect cable it will cranck as much it needs to start
This is trick. I've always wanted a remote start on my rx7 for the same reasons you mention
That’s bs they don’t tell u have to pair the remote
I spent an hour trying to figure it out till I watched your video! 😂
Did you have to put a blade al In the module ?
Hey Bro just startes installing this same device... But wanted to ask you if the small gauge wires that say "trigger starter input" are supposed to be connected.... because my device is not starting the car...and what wire do they go to on the car.... Thank you so much..
hi a have a question you need to programing the madulo by the car?
Did you have to buy everything separately or did the wires came with the compustar box
Came in the box
is soldering required?
I tried installing in my Tacoma that’s manual and I wired everything up right but doesn’t seem to wanna work
So on the 12 pin small Grey connector, you only used the brake and hood input wires and nothing else?
If I wire the 8 pin power harness and the brake, hood, and lock + unlock outputs for my power locks and just wrap up everything else from the 12 pin will the remote start and keyless work? Thank you for the video, it was very helpful
Yes you don't have to connect everything, just cut or wrap the rest
Thank you for the reply and the info! 🙏
For incorporating the power locks. Can you pair the new key fob to the existing power lock system? So the lock or unlock rf signal goes straight to the after market module and not through the remote start module
If not you can use a rf cloner. They come with 4 buttons that will clone most rf signals. You could clone the remote start and lock fobs on to one. You’d just lose the two way feedback
Will the compustar t13 work on the fd?
It should, it's a universal product
@@MohrGarage appreciate the reply and last question is it reliable for u and do u still use it till this day?
I do not use it anymore, I took everything non stock back out to keep it simple
Where did u get the wire coloring system
Tested the wires myself
I remember when push button start was the thing.