KG, thanks for explaining your measurements and what you were doing, not showing off how fast you can crank out an example on a 12” piece of trim, lol. Seriously, I’ve watched countless bending videos and very few explanations. One suggestion for the future is to show everything from the beginning of what you’re doing, the actual measurements (that you did mention) and actually laying it out. Example, there’s one guy that bends a complex profile with crown molding, etc, but never gives any dimensions of the final width, how it’s laid out, etc. same with brake buddy, etc. thanks
With your snips make a small cut that's your mark I lightly bring the others side over that way I get both sides you probably know what i mean I'm just calling it something else
KG, thanks for explaining your measurements and what you were doing, not showing off how fast you can crank out an example on a 12” piece of trim, lol. Seriously, I’ve watched countless bending videos and very few explanations. One suggestion for the future is to show everything from the beginning of what you’re doing, the actual measurements (that you did mention) and actually laying it out. Example, there’s one guy that bends a complex profile with crown molding, etc, but never gives any dimensions of the final width, how it’s laid out, etc. same with brake buddy, etc. thanks
You are quite welcome Jerry and thanks for Tuning in your comment was so encouraging
Nice work your quick. Takes me 20 min to do a piece like that. Mine come out looking like junk.
Thanks for Tuning in Lone Star 🌟 Practice makes perfection your comments are always appreciated
Mine too. Hahahahahha
Practice and stay tuned 😉
I was trying to remember how to do this you don't nip you coil ?
I rip my coil into 5 1/2 strips
@kgtips8787 no instead of marking it with a pen nip mark for the bend
@Shonuff42080 never heard of nipping . What is the process?
With your snips make a small cut that's your mark I lightly bring the others side over that way I get both sides you probably know what i mean I'm just calling it something else
@Shonuff42080 Thanks will try it