Hi, I just followed the diagram in the instructions for bi-polar wiring. four of the wires are joined together in two pairs leaving four wires to connect to the plug to the TB6560 controller. I don't have the colours to hand now. Hope this helps Tony.
hallo i have also a tb6560 stepper driver board but my motors dont run! i have 3 NEMA 23 8 wire motors. the mach3 software was configured with the manuel from cd. i hope you can give me a little tip what the reason for my problem.
Hello Tony, I think I have the same setup you do. I am trying to run Mach3 on my laptop, but it does not have a parallel port. How did you plugged it, PCMCIA, or yours have a parallel port on it? Also I tried to open the link in the description but it requires authentication. Best regards. Francisco
Hi, I just followed the diagram in the instructions for bi-polar wiring.
four of the wires are joined together in two pairs leaving four wires to connect to the plug to the TB6560 controller. I don't have the colours to hand now. Hope this helps
Tony.
how do you put your cables up
hallo i have also a tb6560 stepper driver board but my motors dont run! i have 3 NEMA 23 8 wire motors. the mach3 software was configured with the manuel from cd.
i hope you can give me a little tip what the reason for my problem.
hi mate looking at these controllers on ebay. been told to stay away from them on cnc zone.. did you have problems... its my first build.
cheers buddy
Hello Tony, I think I have the same setup you do. I am trying to run Mach3 on my laptop, but it does not have a parallel port. How did you plugged it, PCMCIA, or yours have a parallel port on it?
Also I tried to open the link in the description but it requires authentication.
Best regards.
Francisco